ar8840p3200w

Remove/install engine hood catch

Type ar · topic 88.40 · version 0100 · 2010-12-20

Applies to: MODEL 172.4

Where it sits

Function group 3 Body › 88 Detachable body components, exterior flaps › 88.40 Engine hood, front flap — Series 172 (models 4**)

EinPAS 29 Drive authorization/security system › 29.16 Locking/unlocking › 29.16.32 Lock/actuation — Series 172 (models 4**)

AR88.40-P-3200W

Remove/install engine hood catch

8.12.10

MODEL 172.4

Remove/install engine hood catch

P88.40-2946-09

Shown with code (U60) Pedestrian protection

1 Engine hood catch

2 Distributor

3 Front end crossmember

4 Cover

5 Rear release cable

6 Bolts

7 Spring U-bolt

S62/42 Right engine hood contact switch (for code (B03) ECO start/stop function)

S62/43 Left engine hood contact switch (with code 551) Antitheft alarm system (ATA) and code (B03) ECO start/stop function) and without code (U60) Pedestrian protection)

8 Front release cable

A38/1 Pedestrian protection Hall sensor + engine hood ATA switch (with code (U60) Pedestrian protection)

B100 Pedestrian protection Hall sensor (with code (U60) Pedestrian protection)

Remove/install

1

Open engine hood and move to vertical position

Installation: Before closing the engine hood check for proper function: When the engine hood is open lock engine hood locks (1) with screwdriver and then unlock engine hood locks (1) with engine hood release lever.

AR88.40-P-1000V

2

Unclip distributor (2) from lock carrier (3) and open cover (4) on distributor (2) with suitable screwdriver

When removing left engine hood lock (1).

3

Unhook rear release cable (5) from distributor (2)

When removing left engine hood lock (1).

4

Remove bolts (6)

*BA88.40-P-1003-01A

5

Remove engine hood lock (1) from lock carrier (3)

6

Unclip left engine hood contact switch (S62/43) or pedestrian protection Hall sensor + ATA engine hood switch (A38/1) or pedestrian protection Hall sensor (B100) from left engine hood lock (1)

Depending on vehicle equipment.

7

Unclip left engine hood contact switch (S62/42) or pedestrian protection Hall sensor (B100) from right engine hood lock (1)

Depending on vehicle equipment.

8

Press spring clip (7) in direction of arrow and unhook front release cable (8) from engine hood lock (1)

9

Unclip outer grommet on front release cable (8) from engine hood lock (1) and remove engine hood lock (1)

10

Install in the reverse order

Engine hood

Number

Designation

Model
172

BA88.40-P-1003-01A

Bolt on engine hood catch

Nm

8

Referenced documents