Remove/install rear apron · ar8830p0502ff · Mercedes-Benz WIS

AR88.30-P-0502FF

Remove/install rear apron

4.8.05

MODEL 454.0 (except 454.034) with CODE (E78) Rear apron, smart BRABUS (DFO)

MODEL 454.034

P88.20-2573-06

1 BRABUS rear apron

2 CBS rear end

3 Bore

4 Guide

5 Lugs

6 Adhesive strips

	Remove
 Danger!	Risk of death caused by vehicle slipping or toppling off of the lifting platform.	Align vehicle between the columns of the lifting platform and position the four support plates at the lifting platform support points specified by the vehicle manufacturer.	AS00.00-Z-0010-01A
1	Raise vehicle.
2	Loosen clamps (arrows) from BRABUS rear apron (1) and CBS rear end (2) with suitable tool and remove
3	Carefully loosen BRABUS rear apron (1) on left and right in area of adhesive strips (6) from CBS rear end (2) with suitable blade and remove.	 Aid of helper required
4	Remove glue residues on adhesive strips (6) from parts to be reused.
	Install
5.1	Check that BRABUS rear apron spoiler (1) fits precisely and then paint.	When replacing BRABUS rear apron (1).
6.1	Clean gluing surfaces of adhesive strips (6) on left and right on BRABUS rear apron (1)	When reusing removed BRABUS rear apron (1).
		 Bonding surface must be free of dust and grease.
7.1	Mask BRABUS rear apron (1) in area of gluing surfaces with masking tape, coat with primer and allow to air-dry for at least 5 minutes.	When reusing removed BRABUS rear apron (1).
		 Thoroughly remove primer from painted surfaces not to be glued to prevent damage.
		 Primer is included in the repair kit in the form of an impregnated non-woven cloth.
		Repair kit	*BR00.45-Z-1094-02A
8	Clean gluing surfaces on CBS rear end (2).	 Bonding surface must be free of dust and grease.
9	Mask CBS rear end (2) in area of gluing surfaces with masking tape, coat with primer and allow to air-dry for at least 5 minutes.	 Thoroughly remove primer from painted surfaces not to be glued to prevent damage.
		 Primer is included in the repair kit in the form of an impregnated non-woven cloth.
		Repair kit	*BR00.45-Z-1094-02A
10.1	Glue adhesive strips (6) to BRABUS rear apron (1)	When reusing removed BRABUS rear apron (1).
		 Adhesive strips (6) are included in repair kit.
		Repair kit	*BR00.45-Z-1094-02A
11	Position BRABUS rear apron (1) on CBS rear end (2) and align	 The guide (4) should engage in the bore (3). Aid of helper required
12	Remove protective foil on adhesive strips (6) from BRABUS rear apron (1)	 Carefully remove protective foil (6) on adhesive strips from lugs (5) in horizontal direction to prevent lugs (5) from being torn off prematurely
13	Press on BRABUS rear apron (1)	 It no longer possible to align the BRABUS rear apron (1) after pressing the CBS rear end (2). Ensure that BRABUS rear apron (1) is seated properly.
14	Fasten BRABUS rear apron (1) with clamps (arrows)
15	Lower vehicle

Repair materials

Number	Designation	Order number
BR00.45-Z-1094-02A	Repair kit	A 454 899 00 98

Referenced documents

as0000z001001a Risk of death caused by vehicle slipping or toppling off of the lifting platform.