P88.20-2087-09
1 Bumper
2 Fog lamp connector
3 Outside temperature sensor connector
4 Screw
9 Bolts
X26/27 Front bumper Parktronic system (PTS) connector
5 Screw
6 Screws
7 Nuts
8 Lock
P88.20-2088-07
10 Intermediate layer
11 Adjustment nut
1 Bumper
| Removal | ||
1 | Open engine hood | ||
2 | Open flap in engine compartment paneling at bottom | ||
3 | Disconnect fog lamp (2) connector | ||
4 | Disconnect outside temperature sensor (3) connector | ||
5 | Disconnect front bumper Parktronic system (PTS) connector (X26/27) | For this purpose carefully lift lugs (arrows) and simultaneously disconnect connector | |
6 | Unscrew left and right screws (4) | ||
7 | Unscrew left and right screws (5) | ||
8 | Unscrew left and right screws (6) | ||
9 | Unscrew nuts (7) | ||
10 | Slide lock (8) toward front on both sides (arrow) | ||
11 | Remove bumper (1) with aid of second mechanic | For this purpose pull bumper downward to side until bolt (9) releases bumper | |
| Installation | ||
| Ensure that the lock (8) on the bumper (1) is pushed forward on both sides | ||
12.1 | Transfer M AMG bumper | See installation instructions for accessories | |
Retrofitting M AMG paneling sections | |||
13 | Position bumper (1) in relation to body with aid of second mechanic and insert bolt (9) into side of bumper | ||
14 | Push bumper (1) upwards in area of fender and pull back lock (8) | Ensure that the bolt (9) reaches correctly into the lock | |
15 | Position screws (4) and (5) | ||
16 | Position screws (6) | ||
17 | Start nuts (7) on stud | ||
18 | Slide intermediate layer (10) toward outside to stop | This closes the gap between the bumper (1) and the cross member. Reposition intermediate layer (10) with slight force to keep the bumper (1) from being pressed forward | |
19 | Align bumper to correct height and tighten nuts (7) | | |
20 | Tighten screws (6) | ||
21 | Turn adjustment nut (11) on left and right until the bumper (1) is flush with the fender at the side | ||
22 | Tighten left and right screws (5) | ||
23 | Tighten left and right screws (4) | ||
24 | Connect front bumper Parktronic system (PTS) connector (X26/27) | ||
25 | Connect outdoor temperature sensor (3) connector | ||
26 | Connect fog lamp connector (2) | ||
27 | Close flap in engine compartment paneling at bottom |
Bumper
Referenced documents
- az8800p0001g Retrofit AMG trims