B88.20-0005-09
1 | Headlight covering | 3 | Hex screw | ||||
2 | Torx screw | 4 | Electric wire |
B88.20-0005-09
5 | Bolts | 8 | Bumper | |
6 | Bolts | 9 | Front entrance rail | |
7 | Bolts |
| Remove/install | ||
Danger ! | Risk of explosion from explosive gas. Risk of poisoning and caustic burns from swallowing battery electrolyte. Risk of injury through burns to skin and eyes from battery acid or when handling damaged lead-acid batteries | No fires, sparks, open flames or smoking. Wear acid-resistant gloves, clothing and glasses. Only pour battery acid into suitable and appropriately marked containers. | |
1 | Loosen the battery negative cable | ||
2 | Remove the entrance rails (steps) to access the cab, respectively on the right and left sides | Remove/install entrance | |
3 | Disconnect the electrical connectors (4) | ||
4 | Loosen the hex screw (3) | Bumper fastening bolt | |
5 | Loosen the Torx screws (2) and remove the headlight cover (1) | Bumper fastening Torx bolt | |
6 | Loosen the Torx screws (2) | Bumper fastening Torx bolt | |
7 | Loosen the Torx screws (5) | Bumper fastening bolt | |
8 | Loosen the bolts (6) | Bumper fastening bolt | |
9 | Tilt the front entrance rail (9) forward | ||
10 | Loosen the bolts (7) and remove the bumper (8) | Bumper fastening bolt | |
11 | Install on the reverse order | ||
| Check | ||
12 | Check the headlights for operation and alignment | ||
| Check and correct the adjustment of the headlamps |
Referenced documents
- ap8210b8260f Check and correct the adjustment of the headlamps
- ar8830b2305a Remove/install entrance
- as5410z000101a Risk of fire/risk of explosion due to short circuit and escaping oxyhydrogen gas. Risk of (burn) injury caused by caustic burns to eyes, skin and mucous membranes from battery electrolyte/mist, short circuit and arcing. Risk of