T82.10-0051-01
1 Front flap
2 Upper bracket
3 Headlamp trim
4 Cable
5 Spring
6 Lamp unit
7 Bottom bracket
8 Front flap
9 Upper bracket
10 Locating pin
11 Contact bolts
T88.00-0003-01
| Remove/Install | ||
Danger! | Risk of injury to fingers being jammed or squeezed when removing and installing or aligning hoods, doors, trunk lid/tailgate or sliding roof. | When moving components, ensure that no body parts or limbs are within the operating range of moving parts. | |
1 | Open front flap (1) | See Operating Instructions | |
2 | Unscrew hex. nut from upper mount (2) of headlamp trim (3) | ||
3 | Loosen headlamp trim (3) out of its arrest by pulling on cable (4) and pull out toward front | ||
4 | Remove lamp trim (6) from headlamp trim (3) | ||
5 | Unscrew headlamp trim (3) from bottom bracket (7) on vehicle frame and remove headlamp trim (3) | ||
6 | Install in the reverse order | ||
| Inspect | ||
7 | Check gap between headlamp trim (3) and front flap (8), adjust if necessary | ||
Adjust | |||
8 | Adjust gap between headlamp trim (3) and front flap | Adjust gap: Prerequisite: The front flap is located in the correct position. | |
Move headlamp trim (3) in longitudinal direction: - Move upper, left bracket (9) at headlamp trim (3).. - Move bottom bracket (7) on vehicle frame. - Screw spring locating pin (10) into and out of contact bolt (11). | |||
Move headlamp trim (3) in the lateral direction: - Move bottom bracket (7) on headlamp trim (3). - Moving contact bolt (11) on headlamp trim (3). | |||
9.1 | Check headlamp adjustment, correct if necessary | Perform step if gap is newly adjusted (step 8). | |
| Check and correct headlamp adjustment |
Referenced documents
- ap8210t8260a Check and correct headlamp adjustment
- ar8210t4730a Remove/install headlamp unit
- as0000z001101a Risk of injury caused by fingers being jammed or pinched when removing, installing or aligning hoods, doors, trunk lid/rear-end door or sliding roof.