ar8620l0300va

Remove, install rear loading system for wheel chair

Type ar · topic 86.20 · version 0100 · 2005-01-20

Applies to: MODEL 414.700 with CODE (ZY6) Loading system for electrical wheel chairs for handicapped vehicle "Movability"

Where it sits

Function group 3 Body › 86 Emergency equipment, diability equipment, sanitary equipment, galley › 86.20 Disability equipment — Series 414 (models 700)

EinPAS 37 Interior equipment › 37.60 Easy entry and exit feature › 37.60.40 Lift — Series 414 (models 700)

AR86.20-L-0300VA

Remove, install rear loading system for wheel chair

1.12.04

MODEL 414.700 with CODE (ZY6) Loading system for electrical wheel chairs for handicapped vehicle "Movability"

Remove, install rear loading system for wheel chair

N86.20-2002-06

1 Rear loading system

2 Voltage supply connector

3 Release lever

4 Operating unit

Remove/Install

1.1

Remove wheel chair from vehicle

Only required if wheel chair is present

Extend rear loading system (1) for wheel chair and remove wheel chair

2.1

Retract rear loading system (1) for wheel chair

Only required if wheel chair is present

3

Disconnect voltage supply connector (12) from trunk/cargo space 12 V socket

Avoid damaging voltage supply connector (2) and electrical lead by pinching when removing and installing rear loading system (1)

4

Release rear loading system (1) on both sides

Helper required.

By pressing release lever (3) down on left and right side

Installation: Ensure that rear loading system (1) arrests correctly and is seated properly.

5

Pull rear loading system (1) out of floor mount

Helper required.

6

Lift rear loading system (1) out of vehicle with control module (4)

When removing and installing ensure that the rear loading system (1) does not hit against the vehicle to prevent damaging the vehicle.

Helper required.

7

Install in the reverse order

8

Perform function check