Remove/install burner housing/afterburner pipe · ar8370p5600a · Mercedes-Benz WIS

AR83.70-P-5600A

Remove/install burner housing/afterburner pipe

30.11.09

MODEL 210.### 1# up to 636643 with ENGINE 604, 605, 606 with CODE (228) Stationary heater
Thermo Top S heater

MODEL 210.### 1# up to 340566 with ENGINE 602.982
with Thermo Top S heater booster

MODEL 202.### 1# up to 31.5.97
with retrofitted Thermo Top S stationary heater

MODEL 210.### 1# up to 672083 with ENGINE 104, 111, 112, 113, 119 with CODE (228) Stationary heater
Thermo Top S heater

Remove/install burner housing/afterburner pipe

P83.70-0220-12

1 Burner housing

2 Burner tube

3 Screw



The picture shows the removal at the burner housing of the stationary heater unit with coolant recirculation pump. The removal at the heater booster heater unit is performed in the same manner.

Modification notes

25.7.96

Burner housing cannot be exchanged. Notes on the removal of the coolant recirculation pump when changing the burner housing no longer apply.

Operation step 6.1 and 6.2 omitted. The following operation steps move up in rank accordingly. Operation step 7, note added.

 	Remove/install
1	Remove heater unit	Model 202	AR83.70-P-5302AP
		Model 210	AR83.70-P-5302A
2	Remove flame monitor/glow pin		AR83.70-P-5742A
3	Remove burner		AR83.70-P-5770A
4	Remove combustion air blower unit		AR83.70-P-5555A
5	Install control unit/heat exchanger unit		AR83.70-P-5935A
6	Remove screws (3)	 Stationary heater	*BA83.70-P-1003-01A
		 Heater booster  Installation: When installing a new burner tube, use new screws/bolts.	*BA83.70-P-1003-02A
7	Pull burner tube (2) out of burner housing (1)	 The burner housing cannot be exchanged.
8	Install in the reverse order
9	Check emission level, adjust if necessary	Model 202, 210 with stationary heater	AR83.70-P-1177A
		Model 210 with heater booster	AR83.70-P-1177B

 Stationary heater

Number	Designation		Model 202, 203, 210 Thermo Top S heater


BA83.70-P-1003-01A	Screw for combustion chamber	Nm	3

 Heater booster

Number	Designation		Model 210 up to end no. A340 566 with heater booster


BA83.70-P-1003-02A	Screw for combustion chamber	Nm	3

Referenced documents

ar8370p1177a Check emission level, adjust if necessary
ar8370p1177a
ar8370p1177b Checking emission value, adjusting as required
ar8370p5302a Removing and installing stationary heater
ar8370p5302ap Removing and installing stationary heater
ar8370p5555a Remove/install combustion air blower unit
ar8370p5742a Remove/install flame monitor/glow pin
ar8370p5770a Removing and installing burner
ar8370p5935a Remove/install control unit/heat exchanger unit