AR83.70-P-0003RT | Remove and install Telestart receiver | 21.6.06 |
MODEL 251 with CODE (228) Stationary heater
P83.70-4990-06
1 Plastic nuts
2 Retaining clamp
3 Intermediate bottom
4 Lug
5 Electrical connector
6 Antenna connector
7 Bracket
A6/1 STH radio remote control receiver
| Remove/install | ||
| Notes on avoiding damage to electronic components due to electrostatic discharge | ||
1 | Switch off ignition and remove the transmitter key from the EIS [EZS] control unit | On vehicles with Keyless Go, code 889: Press Keyless Go start/stop button repeatedly until ignition is switched off. Remove transmitter key from vehicle and store it in a location beyond its transmission range (at least 2 m). | |
2 | Remove front floor covering | Left. | |
3 | Unscrew plastic nuts (1) and remove intermediate bottom (3). | Installation: Ensure that retaining clip (2) is seated correctly. | |
4 | Press lug (4) to side (arrow B) and remove STH radio remote control receiver (A6/1) out of bracket (7) (arrow A). | ||
5 | Disconnect electrical connector (5) and disconnect antenna connector (6) from STH radio remote control receiver (A6/1). | ||
6 | Install in the reverse order | ||
7 | Teach-in Telestart transmitter | ||
8 | Switch on STH heater unit with STH transmitter key. | As soon as the circulation pump and the combustion air blower of the STH heater unit in the vehicle start up and the fuel metering pump is operating, switch the STH heater unit off. |
Referenced documents
- ah5400p000101a Information on preventing damage to electronic components due to electrostatic discharge
- ar6820p2050rt Remove/install front floor covering (left)
- ar8370p000303gz Teach-in Telestart transmitter