Removing, installing stationary heater antenna

AR83.70-P-0002B

Removing, installing stationary heater antenna

15.10.98

 

Removal, installation



Telestart differentiating characteristics

 With Telestart T70 installed 

Remove stationary heater antenna

AR83.70-P-0002BA



Notes on Telestart differentiating characteristics

Telestart T60, T70

AH83.70-P-0003-03A

1

Disconnect ground cable of battery

AR54.10-P-0003A

2

Remove fuse and relay module (F1)

3

Remove rubber door seal from left front door

4

Remove lower side trim on A-pillar on left side of the vehicle

 First remove the hood release.

AR68.30-P-4050GH

5

Remove top left A-pillar trim

 Merely loosen so that the antenna lead can be routed along this.

6

Disconnect stationary heater antenna (A2/27) from windshield

Installation: Degrease adhering surface with cleaning cloth

7

Loosen roof trim between interior rearview mirror and left A-pillar

Installation: Push antenna lead behind roof trim with a plastic wedge.

8

Remove antenna lead (4) up to Telestart receiver (A6a1)

Installation: Wrap antenna lead with felt strips.

9

Disconnect antenna lead (4) from connector (A2/27x1) at Telestart receiver (A6a1)

Installation: Connect connector hand-tight only.

Installation: Tie excessive antenna lead length back in a ring of at least Ø 50 mm.

10

Install in the reverse order

Testing

11

Switch heater unit (A6) on with Telestart transmitter (A8/3)

 When the heater unit's recirculating pump and combustion air blower start up and the fuel metering pump begins to operate, switch heater unit off.