P83.40-2990-06
Shown on vehicle with COMAND APS USA (with navigation system), code 530 and with comfort automatic air conditioning, code 581
1 Long wedge
2 Instrument panel center section
3 Lugs
4 Bolts
5 Connector
N22 AAC [KLA] control and operating unit
N22/7 Comfort AAC control and operating unit
Modification notes
26.7.06 | Disconnect/connect ground line for battery and carry out basic programming removed | Steps 2 and 8 |
| Remove/install | ||
| Notes on avoiding damage to electronic components due to electrostatic discharge | ||
1 | Switch off ignition and remove the transmitter key from the EIS [EZS] control unit | On vehicles with Keyless Go, code 889: Press Keyless Go start/stop button repeatedly until ignition is switched off. Remove transmitter key from vehicle and store it in a location beyond its transmission range (at least 2 m). | |
2 | Unclip center part of instrument panel (2) using long wedge (1), remove and put down on the center console | Place on a soft underlay, as otherwise the center part of instrument panel (2) and/or the center console can be damaged. | |
Installation: Insert the center part of the instrument panel (2) first with the two bottom lugs in the clips (3) then fold upwards and clip in. | |||
Long wedge | |||
3 | Release plug (5) and disconnect. | ||
4 | Remove bolts (4) | Installation: Pay attention to different lengths of bolts. | |
5 | Remove AAC [KLA] control and operating unit (N22) or Comfort AAC [KLA] control and operating unit (N22/7) | ||
6 | Install in the reverse order |
Long wedge
115 589 03 59 00
Referenced documents
- ah5400p000101a Information on preventing damage to electronic components due to electrostatic discharge