AR83.30-P-5370DA | Removing and installing auxiliary fan preresistor | 26.5.97 |
MODEL 140 as of 1.12.94 up to 31.8.95
P83.30-0836-06
1 Clip
2 Screw clip
4 Screw
B11/4 ECT sensor
M4m1 Left auxiliary fan
M4m2 Right auxiliary fan
R15 Auxiliary fan preresistor
| Removal, installation | ||
1 | Disconnect negative pole on battery | ||
2 | Unclip clips (1) | ||
3 | Unscrew screw clips (2) | ||
4 | Remove grille | ||
5 | Cut off electric lead directly next to auxiliary fan preresistor (R15) | Installation: The auxiliary fan preresistor (R15) is supplied together with the electric lead as a replacement part. Screw on new preresistor with screw (4). Route electric lead behind left headlamp and connect with 2-pin connector | |
6 | Unscrew screw (4) | ||
7 | Remove auxiliary fan preresistor (R15) | ||
8 | Reinstall in opposite order | ||
9 | Check for proper function as follows | ||
10 | Disconnect coolant temperature sensor connector (B11/4) and connect resistance decade to pins 1 and 2. Set resistance decade to 310Ω. | | |
11 | Ignition ON | ||
12 | Set pushbutton control module | ||
13 | Auxiliary fans should rotate to right | After completing the work erase DTC memory in pushbutton control module (diagnosis manual) |
Resistance decade
124 589 09 63 00