ar8325p1401p

Remove and install air inlet

Type ar · topic 83.25 · version 0102 · 2012-02-24

Applies to: MODEL 203

Where it sits

Function group 3 Body › 83 Climate control › 83.25 Automatic heater — Series 203

EinPAS 39 Heating/ventilation/cooling › 39.15 Climate control › 39.15.32 Housing/heat exchanger/evaporator/filter — Series 203

AR83.25-P-1401P

Remove and install air inlet

16.2.12

MODEL 203

Remove and install air inlet

P83.25-2040-06

Shown in model 203.0

1 Snap lock

2 Dust filter housing

4 Water collector

5 Nut

6 Nut

7 Bracket

7a Bolt

Removing, installing

Danger!

Injury Hazard! Windshield wiper mechanism can pinch, crush or, in extreme cases even sever extremities.

Always remove ignition key when working on windshield wiper mechanism.

AS82.30-Z-0001-01A

Danger!

Risk of explosion caused by escaping oxyhydrogen gas. Risk of injury caused by caustic burns to eyes, skin and mucous membranes from battery electrolyte (contains diluted sulfuric acid) or metal spatter due to short circuit. Risk of burn injuries caused by short circuit. Risk of poisoning caused by swallowing battery electrolyte (contains diluted sulfuric acid) or absorption of lead over the skin or orifices

No fire, sparks, open flames or smoking.

Wear acid-resistant gloves and clothing and safety glasses with side guards.

Do not place any conductive objects on the battery and avoid any short circuit from battery positive to ground.

Only fill liquid battery electrolyte (diluted sulfuric acid) into suitable and appropriately marked containers.

AS54.10-Z-0001-01A

Notes on battery

All models

AH54.10-P-0001-01A

1

Open engine hood

2

Open snap locks (1)

3

Loosen bolt (7a)

4

Turn bracket (7) slightly

Installation: Ensure that the bracket (7) is correctly seated at the dust filter housing (2).

5

Remove dust filter housing (2)

6

Pull water collector (4) from windshield frame

Using a pulling hook, loosen water collector (4) from the windshield frame in direction of arrow, and pull out until level with the right wiper axis.

Pulling hook

*140589023300

7

Loosen nuts (5)

8

Unscrew nuts (6)

9

Remove air inlet

Slightly raise water collector (4).

10

Install in the reverse order

Remove and install air inlet

Pulling hook

140 589 02 33 00

Referenced documents