ar8310d2040ts

Remove/install air distribution flap actuator motor

Type ar · topic 83.10 · version 0200 · 2019-11-14

Applies to: Model 907, 910 with code HH4 (THERMOTRONIC automatic climate control) Model 907, 910 with code HH9 (Air conditioner, automatic heater control)

Where it sits

Function group 3 Body › 83 Climate control › 83.10 Ventilation — Series 907 · Series 910

EinPAS 39 Heating/ventilation/cooling › 39.15 Climate control › 39.15.30 Blower motor/actuator motor — Series 907 · Series 910

AR83.10-D-2040TS

Remove/install air distribution flap actuator motor

31.10.2019

Model

907, 910

with code HH4 (THERMOTRONIC automatic climate control)

Model

907, 910

with code HH9 (Air conditioner, automatic heater control)

Modification notes

29.10.2019

"Teach in and normalize actuator motor (1) and erase fault memory using vehicle diagnosis system", added.

Step 9

Remove/install air distribution flap actuator motor

D83.10-1200-79

Shown on model 907 with code FJ6 (Center range with 2 DIN stowage compartments and air vent)

1

Actuator motor

4

Bolts

2

Bolts

5

Electrical connector

3

Equipment installation frame

6

Driver

Topical note

Information on preventing damage to electronic components due to electrostatic discharge

AH54.00-P-0001-01A

Topical note

Notes on carrying out repair work in the vehicle interior

AH68.00-N-0001-01S

Remove/install

1

Switch off ignition and store transmitter key outside of transmission range (min. 2  m).

2.1

Remove head unit.

Model 907, 910 with code E1A (MBCONNECT-5); model 907, 910 with code E1C (Audio 25); model 907, 910 with code EJ2 (Audio 20); model 907, 910 with code EJ9 (COMAND Online)

AR82.85-D-1101TS

2.2

Remove top center trim on instrument panel.

Model 907, 910 with code E1O (Entrance radio); model 907, 910 with code ER0 (Pre-installation for radio); model 907, 910 with code FJ6 (Center range with 2 DIN stowage compartments and air vent)

AR68.10-D-1497TS

3

Remove radio.

Model 907, 910 with code E1O (Entrance radio)

AR82.60-D-7502TS

4

Remove screws (2) and take off device installation frame (3).

Model 907, 910 with code E1O (Entrance radio); model 907, 910 with code ER0 (Pre-installation for radio); model 907, 910 with code FJ6 (Center range with 2 DIN stowage compartments and air vent)

5

Remove screws/bolts (4).

6

Remove actuator motor (1) until the electrical connector (5) is accessible.

7

Disconnect electrical connector (5) and remove actuator motor (1).

Installation: Ensure that the truncation (arrow A) of the driver (6) is aligned with the truncation (arrow B) of the actuator motor (1).

8

Install in the reverse order.

9

Teach in and normalize actuator motor (1) and erase fault memory using vehicle diagnosis system.

AD00.00-D-2000-06TS

Check

10

Carry out function test of actuator motor (1).

Referenced documents