ar8262p8000mp

Removing and installing keyless go antenna

Type ar · topic 82.62 · version 0101 · 2006-10-31

Applies to: MODEL 220.875 /878 with CODE (889) Keyless Go to center door

Where it sits

Function group 3 Body › 82 Electrical system, body › 82.62 Loudspeakers, amplifiers, antennas — Series 220 (models 875, 878)

EinPAS 29 Drive authorization/security system › 29.15 KEYLESS-GO › 29.15.14 Transmitter/receiver — Series 220 (models 875, 878)

AR82.62-P-8000MP

Removing and installing keyless go antenna

19.7.01

MODEL 220.875 /878 with CODE (889) Keyless Go
to center door

Removing and installing keyless go antenna

P82.62-2272-09

1 Door vapor seal

2 Door foils

A2/63 Right center door keyless go antenna

3 Felt tape

A2/62 Left center door keyless go antenna

Remove/Install

Before opening and closing the center door open front and rear door. Center door should be should be slammed, not pushed closed.

1

Remove key from electronic ignition/starter switch control unit

With keyless go, code 889:

Press start/stop button until zero position is activated.

2

Remove door vapor seal (1) and door foils (2) from center door

AR72.14-P-0105MP

3

Expose electrical feed line for left and right center door keyless go antenna (A2/62, A2/63)

Installation: Replace tie straps.

4

Disconnect electrical connector for left and right center door keyless go antenna (A2/62, A2/63)

5

Unclip left and right center door keyless go antenna (A2/62, A2/63) and remove

When installing new keyless go antenna:

Replace felt tape (3)

Anti-rattle tape (self-adhesive felt tape).

*BR00.45-Z-1046-02A

6

Install in the reverse order

Repair materials

Number

Designation

Order number

BR00.45-Z-1046-02A

Anti-rattle tape
Art. no. 34722

Kent Industries Deutschland
Am Nordkanal 8
47877 Willich
Germany
Tel. +49 2154 9567-0
Fax +49 8001885 140
www.kenteurope.com

Referenced documents