ar8235s6000ca

Remove/install washer fluid reservoir of windshield washer system

Type ar · topic 82.35 · version 0101 · 2018-11-17

Applies to: Model 415

Where it sits

Function group 3 Body › 82 Electrical system, body › 82.35 Windshield washing system — Series 415

EinPAS 36 Visibility › 36.30 Wiping/washing › 36.30.41 Pump/container/heat exchanger — Series 415

AR82.35-S-6000CA

Remove/install washer fluid reservoir of windshield washer system

16.11.2018

Model

415

Remove/install washer fluid reservoir of windshield washer system

1

Washer fluid reservoir

2

Filler neck

3

Lock

4

Lock

S82.35-4520-06

Remove/install

Danger

Risk of death caused by vehicle slipping or toppling off of the lifting platform.

Align vehicle between vehicle lift columns and position the four support plates at the vehicle lift support points specified by the vehicle manufacturer.

AS00.00-Z-0010-01A

Topical note

Special instructions for lifting and supporting vehicle

AH00.60-N-0100-01TS

1

Open hood

2

Remove filler neck (2)

To do this, unhook filler neck (2) and remove upward.

3

Loosen front section of right fender liner

AR88.10-S-1310C

Do not remove front section from fender liner completely.

4

Detach right front bumper

AR88.20-S-2000C

It is not necessary to completely remove bumper.

5

Remove windshield washer system pump from washer fluid reservoir (1)

AR82.35-S-6002C

It is not necessary to disconnect the connections of the windshield washer system pump.

6

Remove washer fluid reservoir (1)

To do this, unhook washer fluid reservoir (1) from locks (3, 4).

7

Install in the reverse order

Referenced documents