Remove/install washer fluid reservoir of windshield washer system

AR82.35-P-6000LF

Remove/install washer fluid reservoir of windshield washer system

13.06.2014

MODEL

217

MODEL

222

Shown on MODEL 222 with CODE 874 (MAGIC VISION CONTROL, heated)

1

Washer fluid reservoir

6

Coolant line

11

Heat exchanger (with CODE 874 (MAGIC VISION CONTROL, heated))

2

Expansion rivet

7

Electrical connector

12

Electrical connector

3

Cover

8

Coolant lines

M5/1

Windshield washer system pump

4

Intake air duct upstream of air filter

9

Coolant expansion reservoir

S42

Windshield washer system washer fluid level switch

5

Screw

10

Screw

 Danger !

Risk of death caused by vehicle slipping or toppling off of the lifting platform.

Align vehicle between vehicle lift columns and position the four support plates at the vehicle lift support points specified by the vehicle manufacturer.

AS00.00-Z-0010-01A

 

Remove/install

2

Raise vehicle

3

Remove expansion rivet (2) from right front fender liner

 Clip remover

*452589016300

4

Open engine hood

5

Remove right intake air duct upstream of air filter (4)

6

Remove cover (3)

7

Unclip coolant line (6) from washer fluid reservoir (1)

8

Unclip coolant lines (8) from washer fluid reservoir (1)

9

Disconnect electrical connector (7)

10

Remove screw/bolt (5)

11

Unclip coolant expansion reservoir (9) from the supports and place to one side with connected coolant lines (8)

12

Remove screws/bolts (10)

13

Raise washer fluid reservoir (1) far enough until the windshield washer system pump (M5/1) is accessible

14

Remove windshield washer system pump (M5/1) from washer fluid reservoir (1) and place to one side with connected electrical line and washer fluid hose

 Collect washer fluid which flows out.

 Installation: Replace seal.

 Mounting wedge

*110589035900

15

Remove infrared camera washer fluid pump from the washer fluid reservoir (1) and place to one side with connected electrical line and washer fluid hose

MODEL 217, 222
with CODE 610 (Night View Assist Plus)

 Installation: Replace seal.

 Mounting wedge

*110589035900

16

Disconnect electrical connection (12)

17

Remove heat exchanger (11) from washer fluid reservoir (1) and place to one side with connected coolant lines

MODEL 217
MODEL 222
with CODE 874 (MAGIC VISION CONTROL, heated)

18

Take off washer fluid reservoir (1)

19

Remove switch for windshield washer system washer fluid level (S42) from washer fluid reservoir (1)

When replacing the washer fluid reservoir (1).

20

Install in the reverse order

21

Fill washer fluid reservoir (1)



AP82.35-P-8210HA