S82.30-4520-06
1 Bolt
2 Nut
3 Nut
4 Refrigerant line
5 Refrigerant line
6 Sealing ring
7 Water drain hose
8 Cover
9 Nut
10 Wiper arm
11 Wiper linkage
12 Wiper linkage
13 Lever
14 Lever
15 Clip
16 Washer
17 Sealing ring
18 Nut
19 Bolt
20 Basic carrier
21 Washer
22 Rubber disk
M13 Wiper motor
| Remove/Install | ||
Do not damage painted or plastic parts. | |||
1 | Switch off ignition | ||
2.1 | Discharge air conditioning system | Only for code H06. | |
3.1 | Undo bolt (1). | Only for code H06. | |
Hold nut (2) steady. | |||
4.1 | Unscrew nut (3) | Installation: After each intervention in the air conditioning system, the fluid reservoir is to be replaced. | |
Only for code H06. | |||
| |||
5.1 | Pull out refrigerant lines (4, 5) from the expansion valve and place to one side | Installation: Install new sealing rings (6) and moisten with compressor oil. | |
Only for code H06. | |||
6.1 | Remove air cleaner cross pipe | Cover up intake port. | |
Only with engine 611. | |||
7 | Pull out water drain hose (7) from bulkhead lining | ||
8 | Remove cover (8) | ||
9 | Undo nuts (9) from wiper arm (10) | | |
10 | Remove wiper arm (10) | Note installation position of wiper arm (10). | |
11 | Remove wiper motor (M13) | ||
12 | Unclip wiper linkage (11, 12) on lever (13, 14) | Note installation position. | |
Installation: Press on wiper linkage's bushing (11, 12) using a suitable pair of pliers onto the cone of the lever (13, 14). | |||
13 | Press out clips (15) and remove washers (16) | Installation: Note position of sealing rings (17). | |
14 | Pull out levers (13, 14) | Note installation position. | |
15 | Loosen nuts (18) | Do not remove nuts (18). | |
| |||
16 | Undo basic carrier (20) bolts (19) of wiper motor (M13) at firewall | | |
17 | Unscrew nuts (18) and take out washers (21) | Installation: Note position of rubber disks (22). | |
Installation: Do not fully tighten nuts (18). | |||
18 | Remove basic carrier (20) of wiper motor (M13) to the left | Do not damage the water drain hose (7) and vacuum lines on the brake booster. | |
19 | Install in the reverse order |
Windshield wiper
Number | Designation | Model | |
BA82.30-N-1001-01A | Nut for windshield wiper on wiper shaft | NM | 25 |
BA82.30-N-1002-01A | Nut for rear window wiper on wiper shaft | NM | 15 |
BA82.30-N-1003-01A | Screw for wiper linkage on firewall | NM | 8 |
BA82.30-N-1004-01A | Nut for windshield wiper basic carrier on firewall | NM | 18 |
Air conditioning system
Referenced documents
- ar0910s8031a Removing and installing air cleaner crosspipe
- ar8230s6800a Remove/install wiper motor
- ar8330s1760a Drain, evacuate and recharge air conditioning, check for proper operation and check for leaks
- ar8330s6520a Remove/install fluid reservoir