P82.30-2517-09
1 Wiper system
2 Wiper motor crank
3 Wiper linkage
M6/1 Wiper motor
4 Bolts
5 Electrical connector
| Remove/install | ||
Danger! | Risk of injury in the form of trapping or crushing, or even severing of limbs, if caught in windshield wiper mechanism | Always remove ignition key when working on windshield wiper mechanism. | |
1 | Move the wiper arms into park position and switch off the wiper system (1) | ||
2 | Switch off ignition and remove transmitter key from EIS control unit | The wiper system (1) may switch on by itself when the ignition is on as a result of the rain sensor on the windshield. | |
On vehicles with Keyless Go, code 889: Press Keyless Go start/stop button repeatedly until ignition is switched off. Remove transmitter key from vehicle and store it in a location beyond its transmission range (at least 2 m). | |||
3 | Remove water repellent over wiper system | ||
4 | Turn engine crank (2) on wiper motor (M6/1) to left (arrow) until all bolts (4) are accessible. | ||
5 | Unclip wiper linkage (3) from engine crank (2). | ||
6 | Unscrew bolts (4) and lay wiper motor (M6/1) down to side | | |
7 | Disconnect electrical connector (5) | ||
8 | Remove wiper motor (M6/1) | ||
9 | Install in the reverse order | ||
10 | Carry out function check of the windshield wipers and the windshield washer system | ||
| Windshield wipers, windshield washer system and headlamp cleaning system - function check |
Windshield wiper
Referenced documents
- ap8230p8252rt Windshield wipers, windshield washer system and headlamp cleaning system - function check
- ar8325p1406rt Remove/install water drain above windshield wiper system
- as8230z000101a Injury hazard from pinching and crushing, in extreme cases extremities can even be cut off when caught in windshield wiper mechanism.