B82.30-0004-06
1 Cover
2 Windshield wiper bearing shaft
3 Wiper arm locknut
4 Windshield wiper arm
5 Screws
6 Windshield wiper water ejectors expansion plug screws
7 Windshield wiper water ejectors expansion plug
8 Assist grip
9 Drive shaft
10 Windshield wiper motor shaft
11 Panelling
B82.30-0005-06
2 Windshield wiper bearing shaft
12 Bearing support
13 Drive shaft
14 Water pipe connection
15 Screws
16 Washers
| Remove and install | ||
1 | Remove the front end cover of the cab | ||
2 | Place the windshield wiper in its rest position | The windscreen wiper must be switched off and must have finished its sweep cycle | |
3 | Open the top layer (1) from the windshield wiper arm (4) on the bearing shaft (2) | ||
4 | Remove the nut (3) from the windshield wiper bearing shaft | ||
5 | Loosen the wiper arm (4) from the bearing shaft with a rocking movement | The windshield wiper arm fits the bearing shaft on thin cogged cone. Install: Adjust the arms of the windshield wiper so that the blades remain in a horizontal position and rest against the bottom edge of the windshield. | |
6 | Remove the screws (6) from the windshield wiper water ejectors expansion plug (7) | ||
7 | Remove the windshield wiper water ejectors expansion plug (7) | ||
8 | Loosen the screws (5) and remove the support handles (8) on both sides | ||
9 | Remove the lining (11) | ||
10 | Remove the drive shafts (9) from the windshield wiper motor shaft (10) | Install: The drive shafts should be in the horizontal position to the tight (3 o'clock position). | |
11 | Disconnect the water pipe (14) from the windshield wiper in the connection with flexible piping | ||
12 | Remove the bearing stands (12) from both sides | ||
13 | Remove the drive shafts (13) together with the bearing stands | ||
14 | Install in reverse order |
Referenced documents
- ar8860b2901c Removing and installing front flap