P82.10-4348-06
1 Plug
2 Clamps
3 Bolts
E21 Center high-mounted stop lamp
| Removing | ||
1 | Open tailgate | ||
2 | Remove stop plug (1) | Avoid damaging paint! | |
3 | Remove bolts (3) | Avoid damaging paint! Screw bolts (3) in through the holes (arrow A). Do not drop the bolts (3) in the rear-end door. | |
4 | Pull off clamps (2) | Do not drop in the rear-end door. | |
5 | Close rear-end door | ||
6 | Pull center high-mounted stop lamp (E21) far enough out until the electrical connector is visible | Avoid damaging paint! | |
7 | Detach electrical connector from center high-mounted stop lamp (E21) | ||
| Install | ||
8.1 | Fit clips (2) into center high-mounted stop lamp (E21) | Only if the center high-mounted stop lamp (E21) is used again. Ensure that the clips (2) are correctly seated. Install longer end (arrow B) of the clips (2) upwards. | |
9.1 | Screw in screws (3) | Only if the center high-mounted stop lamp (E21) is used again. | |
10 | Connect electrical connector | ||
11 | Insert center high-mounted stop lamp (E21) | The center high-mounted stop lamp (E21) must latch audibly into place. |