ar8210p4000p

Remove/install headlamp range controller

Type ar · topic 82.10 · version 0301 · 2008-03-25

Applies to: MODEL 203.0 /2, 203.7## #A, 203.7## #E up to 035817, 209 except CODE (612) Xenon headlamp unit except CODE (614) Bi-xenon headlamp unit

Where it sits

Function group 3 Body › 82 Electrical system, body › 82.10 Exterior lights — Series 203 (models 0**, 2**, 7**) · Series 209

EinPAS 30 Lighting system › 30.15 Exterior lights › 30.15.12 Sensor/switch/wiring harness — Series 203 (models 0**, 2**, 7**) · Series 209

AR82.10-P-4000P

Remove/install headlamp range controller

11.3.08

MODEL 203.0 /2,
203.7## #A,
203.7## #E up to 035817,
209
except CODE (612) Xenon headlamp unit
except CODE (614) Bi-xenon headlamp unit

Remove/install headlamp range controller

P82.10-3756-06

Shown on Model 203.0

1 Headlamp range controller

2 Connections

3 Hoses

4 Pneumatic lines

S1 Light switch module

Modification notes

24.5.06

"Disconnect/connect battery ground line" removed

Removing

1

Remove light switch module (S1)

AR54.25-P-3270P

2

Mark pneumatic lines (4) and cut through directly behind connections (2) at headlamp range controller (1)

Install

3

Attach hoses (3) to connections (2) of headlamp range controller (1)

Use hoses (3) with an inside diameter of 3.5 mm.

4

Slide pneumatic lines (4) into hoses (3)

Pay attention to mark on pneumatic lines (4).

5

Install light switch module (S1)

AR54.25-P-3270P

Referenced documents