W07.15-0079-09
A, B, C, D Displays in HHT
E Display in FDOC
1 | Connect hand-held tester (HHT) to vehicle | Hand-held Tester (HHT) | |
Test cable (multiplexer) | |||
Adapter cable for 14-pin diagnostic socket | |||
HHT operating instructions | |||
Case | |||
Commercial vehicle test module | |||
2 | Switch on ignition | ||
3 | Call PLD system (MR) in HHT | To perform work "Learn in key" a FDOC access authorization is required If measuring values of the FMR system are indicated on the instrument cluster, switch off ignition | |
Switch on ignition after approx. 7 s | |||
4 | Call menu "Learn in key" | Display (A) appears on the HHT. Select menu 1 if - the PLD (MR) control module or the engine is replaced - an additional new key is required for the vehicle. Select menu 2 if - one or more keys are lost and should not longer be valid. | |
5 | Select menu 1 or 2 | Display (B) appears on the HHT | |
6 | Note all values of display (B) | These values are required for entering into FDOC | |
7 | Select display 10 "Commercial vehicle" in FDOC | ||
8 | Select display 1801 "Learn in immobilizer key" | ||
9 | Enter vehicle ident no. | The remaining vehicle data is entered automatically into the headline of the display by FDOC (E). | |
10 | Enter values taken from HHT into display (E) in FDOC. | Enter "X" in FDOC in front of the number in line calculation type (item 3) As of module 3.97 an "X" is also displayed on the HHT. | |
11 | Enter number of ordering shop in display (E) in FDOC and confirm with enter key (to release data). | The coded random number is calculated and indicated on the display. | |
12 | Switch over to next display (D) with the ENTER key on the HHT. | ||
13 | Enter coded random number from FDOC and acknowledge with enter key | When the display (C) appears on the HHT, the coded random number has been recognized as correct and the first transponder key is learned in. For each additional transponder key to be learned in, repeat steps 3 through 13. If more than one key is learned in, the control module shut-off delay (duration approx. 2 minutes) should be completed before the next key can be learned in.However, if the next key is nevertheless learned in the HHT indicates "Key already learned in". The vehicle starts in this phase with the key which is not yet learned in.When the ignition is switched off, the vehicle can no longer be started with this key. For this reason it is necessary to learn in the key again in this case. |
Commercially available tools
Number | Designation | |
WH58.30-Z-1036-13A | Handheld tester (HHT) | 651 100 01 99 |
WH58.30-Z-1037-13A | Test cable (multiplexer) | 651 100 40 99 |
WH58.30-Z-1039-13A | Adapter cable for 14-pin diagnostic socket | 651 101 40 99 |
WH58.30-Z-1040-13A | HHT operating instructions | 651 100 21 00 |
WH58.30-Z-1041-13A | Case | 651 101 60 99 |
WH58.30-Z-1042-13A | Commercial vehicle test module | 651 156 00 00 |