ar8050s0004e

Remove/install ATA engine hood switch

Type ar · topic 80.50 · version 0102 · 2016-02-29

Applies to: Model 447 with code FY1 (Anti-Theft Protection package) Model 447 with code FZ5 (Anti-theft alarm system) Model 448.8 with code FZ5 (Anti-theft alarm system)

Where it sits

Function group 3 Body › 80 Central locking system, convenience operation, drive authorization systems › 80.50 Anti-theft alarm system (ATA), Interior motion sensor/Tow sensor — Series 447 · Series 448 (models 8**)

EinPAS 29 Drive authorization/security system › 29.20 Anti-theft alarm system › 29.20.12 Sensor/switch/wiring harness — Series 447 · Series 448 (models 8**)

AR80.50-S-0004E

Remove/install ATA engine hood switch

14.12.2015

Model	447
	with code FY1 (Anti-Theft Protection package)
Model	447
	with code FZ5 (Anti-theft alarm system)
Model	448.8
	with code FZ5 (Anti-theft alarm system)

Remove/install ATA engine hood switch

Shown on model 447.8

4	Mounting clip
5	Cover

S80.50-4527-05

Remove/install ATA engine hood switch

S80.50-4515-08

1	Engine hood catch		3	Electrical connector
2	Cover		S62/41	Engine hood switch

 	Remove/install
1	Open engine hood
2	Remove retaining clips (4) and remove cover (5)	 Installation: Check retaining clips (4).
		If retaining clips (4) are damaged
		
		Replace corresponding retaining clip (4).
3	Disconnect electrical connection (3)
4	Lift catch hooks (arrows A) on cover (2) with suitable screwdriver and unclip cover (2) with engine hood switch (S62/41) in direction of arrow	 Installation: Ensure that hook (arrow B) and catch hooks (arrows A) are seated correctly on engine hood lock (1).
5	Install in the reverse order
	Check
6	Close engine hood lock (1) with suitable tool when engine hood is open and lock vehicle with remote control	 The anti-theft alarm system (ATA) is activated after approx. 10 seconds.
7	Open engine hood lock (1) with suitable tool	 This should trigger the alarm. The alarm can be switched off with the transmitter key when opening the vehicle.