ar8050p9840c

Removing and installing ATA alarm signal siren

Type ar · topic 80.50 · version 0101 · 2006-07-26

Applies to: MODEL 129 as of 1.6.98 with CODE (551a) Anti-theft alarm (ATA)

Where it sits

Function group 3 Body › 80 Central locking system, convenience operation, drive authorization systems › 80.50 Anti-theft alarm system (ATA), Interior motion sensor/Tow sensor — Series 129

EinPAS 29 Drive authorization/security system › 29.20 Anti-theft alarm system › 29.20.20 Horn — Series 129

AR80.50-P-9840C

Removing and installing ATA alarm signal siren

24.3.98

MODEL 129 as of 1.6.98 with CODE (551a) Anti-theft alarm (ATA)

Removing and installing ATA alarm signal siren

P80.50-2021-11

1 Pop rivet

2 Electrical connection

3 Holder

H3/1 Alarm signal siren

Removal, installation

1

Remove right inner fender

ra88001290130x

2

Drill out or cut out pop rivets (1)

To drill out: Use 7 mm dia. bit

Drill with slightly circular motion until rivet head falls off, do not drill through sheet metal

To cut off: Use spherical cutter

*WH58.30-Z-1002-01A

3

Disconnect connector (2) from alarm signal siren (H3/1)

Before disconnecting the siren, ensure that the anti-theft alarm (ATA) is deactivated because otherwise the siren is activated.

(Rechargeable battery for internal power supply)

4

Remove mount (3) from alarm siren signal (H3/1)

5

Install in opposite order

Commercially available tools

Number

Designation

WH58.30-Z-1002-01A

Ball cutter, dia. 12 mm

Referenced documents