ar8050p9830ff

Remove/install anti-theft alarm system (ATA) control unit

Type ar · topic 80.50 · version 0101 · 2005-02-08

Applies to: MODEL 454.0 with CODE (V01) Anti-theft alarm system (FFO)

Where it sits

Function group 3 Body › 80 Central locking system, convenience operation, drive authorization systems › 80.50 Anti-theft alarm system (ATA), Interior motion sensor/Tow sensor — Series 454 (models 0**)

EinPAS 29 Drive authorization/security system › 29.20 Anti-theft alarm system › 29.20.11 Control unit/relay — Series 454 (models 0**)

AR80.50-P-9830FF

Remove/install anti-theft alarm system (ATA) control unit

7.9.04

MODEL 454.0 with CODE (V01) Anti-theft alarm system (FFO)

Remove/install anti-theft alarm system (ATA) control unit
Remove/install anti-theft alarm system (ATA) control unit

P80.50-2427-01

1 Wiring harness

2 Air duct

N26 EDW control unit

P80.50-2428-01

Remove/Install

Notes on avoiding damage to electronic components due to electrostatic discharge

AH54.00-P-0001-01A

1

Remove top part of instrument panel

AR68.10-P-1020FF

2

Unclip wiring harness (1)

3

Remove air duct (2)

4

Remove ATA control module (N26)

Installation: Connections (arrows) for ATA control module (N26) point toward inside of vehicle

Note software status printed on ATA control module (N26).

5

Install in the reverse order

6.1

Program ATA control module (N26)

Only when replacing

ATA control module (N26).

Program anti-theft alarm system (ATA)

Observe software status

AZ80.50-P-0002-17FF

7

Check anti-theft alarm system (ATA)

Referenced documents