ar8020p4007src

Removing and installing tailgate central locking actuating motor

Type ar · topic 80.20 · version 0100 · 2016-01-25

Applies to: Model 453.4

Where it sits

Function group 3 Body › 80 Central locking system, convenience operation, drive authorization systems › 80.20 Central locking system, interior central locking — Series 453 (models 4**)

EinPAS 29 Drive authorization/security system › 29.16 Locking/unlocking › 29.16.31 Actuator motor/actuator — Series 453 (models 4**)

AR80.20-P-4007SRC

Removing and installing tailgate central locking actuating motor

12.1.16

Model

453.4

Removing and installing tailgate central locking actuating motor

1	Central locking actuator motor
2	Electrical connector
3	Screw
4	Screw
5	Retaining plate
6	Cables
7	Support

P72.20-3498-05

 Danger !	Risk of injury caused by fingers being jammed or pinched when removing, installing or aligning hoods, doors, trunk lid/rear-end door or sliding roof.	No parts of the body or limbs should be within the operating area when the components are moving.	AS00.00-Z-0011-01A
 	Remove/install
1	Remove outer trim from liftgate		AR72.20-P-1016SRA
2	Release and disconnect electrical connection (2)
3	Remove wires (6) from mount (7)	 Observe installation position of wires (6) in mount (7).
4	Unscrew bolt (3)
5	Loosen screw (4)
6	Swivel retaining plate (5) to the right
7	Remove central locking actuator motor (1)
8	Install in the reverse order
	Check
9	Check function of central locking actuator motor (1) by mechanically locking liftgate latches and actuating the trunk lid/liftgate release switch

Referenced documents

ar7220p1016sra Remove/install outside trim on liftgate
as0000z001101a Risk of injury caused by fingers being jammed or pinched when removing, installing or aligning hoods, doors, trunk lid/rear-end door or sliding roof.