ar7733p0001src

Remove/install folding roof cassette soft top lock

Type ar · topic 77.33 · version 0100 · 2016-01-25

Applies to: Model 453.4

Where it sits

Function group 3 Body › 77 Sliding roof, soft top, top attachments › 77.33 Vario roof, soft top - mechanical system — Series 453 (models 4**)

EinPAS 38 Roof system › 38.20 Soft top/coupé roof/vario roof › 38.20.30 Soft top/soft top frame — Series 453 (models 4**)

AR77.33-P-0001SRC

Remove/install folding roof cassette soft top lock

13.1.16

Model

453.4

Remove/install folding roof cassette soft top lock

Shown on left side of vehicle

1

Soft top lock

2

Electrical wiring harness

3

Bolts

4

Screw

5

Screw

6

Switches

7

Carrier plate

P77.33-2217-06

Notes on self-locking nuts and bolts

AH00.00-N-0001-01A

Notes on soft tops

AH77.30-P-0001-01MCO

Remove/install

1

Remove guide tubes of relevant drive cable

AR77.30-P-1112SRC

2

Unhook electrical wiring harness (2) from roof cassette

3

Remove bolts (3)

4

Pull soft top lock (1) upwards at rear

Removal: This releases the soft top lock (1).

Installation: Lock soft top lock (1) using pin of B-pillar latch.
Pay attention to routing of wiring harness (2).

5

Unscrew bolt (4)

6

Pull soft top lock (1) upwards and out, and turn over

7

Uncrew bolts (5) and remove carrier plate (7) of soft top lock (1)

Observe installation location of bolts (5).

8

Unclip switches (6) and place to one side


The guide pins and spring steel sheets must not be damaged or bent.
Otherwise the soft top may suffer malfunction or damage.

Only one switch (6) is installed on right side of vehicle.
The switches (6) may be replaced individually.

9

Install in the reverse order

Referenced documents