Open/close panoramic sliding sunroof with emergency actuator

AR77.21-S-2017E

Open/close panoramic sliding sunroof with emergency actuator

01.03.2016

Model

447.7/8, 448.8

1

Hole

S15

Panoramic sliding sunroof roller sun blind switch

b

Dimension

2

Rear headliner

a

Dimension

X

Direction of travel

Emergency actuation shown with rear headliner (2) installed

1

Hole

2

Rear headliner

3

Allen wrench 4 mm

M12

Panoramic sliding roof drive unit

 Danger !

Risk of injury caused by fingers being jammed or pinched when removing, installing or aligning hoods, doors, trunk lid/rear-end door or sliding roof.

No parts of the body or limbs should be within the operating area when the components are moving.

AS00.00-Z-0011-01A



Notes on carrying out repair work in the vehicle interior

AH68.00-N-0001-01S

Opening, closing

1.1

Make a hole (1) in rear headliner (2) as shown

Make a hole (1) if the customer permits.


Take care when making hole (1).
Otherwise, parts in this area above the rear headliner (2) may be damaged.

 Before performing the work, obtain the customer's permission to make a hole (1) in the rear headliner (2).
When the work is complete, the hole (1) is sealed with a blind plug.

 Dimension (a): 90 mm.
Dimension (b): 5 mm.
Ø of hole (1): 5 mm.

1.2

Remove rear headliner (2)

Model 447.8
except code ZK7 (Equipment line MARCO POLO)
Model 448.8
If customer does not permit a hole (1) to be made.

AR68.30-S-7608E

2

With the aid of a 4 mm Allen wrench (3), as shown, open or close the panoramic sliding sunroof drive unit (M12)

 If rear headliner (2) is installed, use a 4 mm Allen wrench (3) with ball head (arrow A).

3.1

Seal the hole (1) with a blind plug

If a hole (1) has been made in the rear headliner (2).

 The blind plug can be obtained from EPC.

3.2

Install rear headliner (2)

Model 447.8
except code ZK7 (Equipment line MARCO POLO)
Model 448.8
If rear headliner (2) has been removed.

AR68.30-S-7608E