AR77.20-S-2500A | Removing and installing wind deflector | 12.9.96 |
MODEL 638
with CODE (D23) pop-up glass roof in passenger area
with CODE (D28) pop-up glass roof in driver area
S77.10-0002-12
1 Pop-up roof frame
2 Cover
4 Screw
5 Screw
6 Screw
8 Wind deflector
9 Guide
S77.20-0001-01
Tightening pattern
1-19 5x14 plastic screw
20-21 5x20 plastic screw
22-24 5x14 plastic screw
25-26 5x20 plastic screw
27-28 5x14 plastic screw
Front of car
A Centering punch
B Roof centering
| Removal | ||
1 | Remove pop-up roof cover (2) downward | ||
2 | Remove glass pop-up roof cover | ||
3 | Loosen screws (1-28) | Torx bit set | |
4 | Remove wind deflector (8) | ||
| Installation | ||
5 | Install wind deflector (8) | Clean dirt off of body surface and gasket. Ensure that gaskets are seated properly. | |
6 | Screw in screws (1-28) | Observe tightening pattern. | |
| |||
Torx bit set | |||
7 | Install glass pop-up roof cover | ||
8 | Install pop-up roof cover (2) | ||
| Checking | ||
9 | Fasten water hose at front and spray pop-up roof with water for approx. 10 minutes. | If leaky remove wind deflector again and check leaky point. |
Electric sliding roof
Torx bit set
000 589 01 10 00
Referenced documents
- ar7710s2010a Removing and installing pop-up roof glass cover