ar7720p1400tx

Remove/install cable

Type ar · topic 77.20 · version 0100 · 2004-10-13

Applies to: MODEL 219.3 with CODE (414) Glass electric tilting/sliding roof

Where it sits

Function group 3 Body › 77 Sliding roof, soft top, top attachments › 77.20 Electric sliding roof — Series 219 (models 3**)

EinPAS 38 Roof system › 38.15 Sliding roof/panoramic sliding sunroof › 38.15.30 Drive unit — Series 219 (models 3**)

AR77.20-P-1400TX

Remove/install cable

12.8.04

MODEL 219.3 with CODE (414) Glass electric tilting/sliding roof

Remove/install cable

P77.20-2500-09

Shown on left cable

1 Cable

2 Water drain channel

3 Long wedge

6 Cover

7 Bolts

4 Screw

5 Tilting bracket

Remove/Install

1

Remove tilting/sliding roof panel

AR77.20-P-1000TX

2

Remove overhead control panel control unit

Leave mounts for tilting/sliding roof cover in pop-up position

AR82.20-P-1000TX

3

Remove tilting/sliding roof motor

Installation: Before installing tilting/sliding roof motor, slide pop-up bracket (5) toward front to stop.

AR77.20-P-3010TX

4

Unclip water drain channel (2) from left and right bracket with long wedge (3) and remove

*115589035900

5

Unscrew bolt (4) from cable (1) on pop-up bracket (5)

6

Slide pop-up bracket (5) approx. 6 cm toward rear

7

Unscrew bolts (7) from cover (6) and remove cover (6) upward

8

Slide cable approx. 10 cm toward rear

9

Remove cable (1) from slide rail and pull out toward rear

Carefully pull out cable (1)Danger of damaging paint on vehicle roof.

10

Install in the reverse order

Remove/install cable

Long wedge

115 589 03 59 00

Referenced documents