Remove, install cable

AR77.20-P-1400P

Remove, install cable

26.10.99

 

Removing, installing

Danger!

Risk of injury to fingers being jammed or squeezed when removing and installing or aligning hoods, doors, trunk lid/tailgate and sliding roof.

When moving components ensure that no body parts or limbs are in the area of movement.

AS00.00-Z-0011-01A

1

Remove sliding/pop-up roof cover

AR77.20-P-1000P

2

Operate sliding roof switch in close direction until the sliding roof drive switches off

3

Remove water drain channel (6)

4

Detach overhead control panel (N70)

 refer to

Remove and install overhead control panel control module

AR82.20-P-1000P

5

Slacken bolts (1)



*BA77.20-P-1002-01A

 Torx bit set

*000589011000

6

Decouple sliding roof drive from sliding/tilting roof surround

 until the drive gear is no longer meshed with the cables (7).

Installation:

Before fastening sliding roof drive, check position of tip (8) in relation to edge of lever (9). The tip in the opening on the tilting bracket should coincide with the edge of the lever in front. Correct tilting bracket if necessary.



*BA77.20-P-1003-01A

7

Unscrew screws (2) on both sides

8

Remove screws (3) on both sides

9

Pull off cover (4) in direction of arrow on both sides

10

Push tilting bracket (5) approx. 10 cm to rear on both sides

11

Push cable (7) forward about 10 cm on both sides

12

Pull out pull cable (7) toward rear on both sides

13

Install in the reverse order

Number

Designation

Model 203.0/2

BA77.20-P-1002-01A

Screw on sliding roof drive

TORX

Nm

4

Hexagon socket

Nm

4

BA77.20-P-1003-01A

Screw on sliding/pop-up roof frame

Nm

8