ar7720p1400gc

Removing and installing control cable

Type ar · topic 77.20 · version 0100 · 1997-07-09

Applies to: MODEL 168

Where it sits

Function group 3 Body › 77 Sliding roof, soft top, top attachments › 77.20 Electric sliding roof — Series 168

EinPAS 38 Roof system › 38.15 Sliding roof/panoramic sliding sunroof › 38.15.30 Drive unit — Series 168

)

AR77.20-P-1400GC

Removing and installing control cable

8.4.97

MODEL 168

Removing and installing control cable

P77.20-0395-09

Illustrated with lamella roof frame removed

1 Pull cable
2 Screw

6 Catch in slider
7 Opening for catch

3 Lever
4 Slider
5 Connector

Removal, installation

1

Remove lamellas on lamella roof

AR77.20-P-1110GC

AR77.20-P-1120GC

AR77.20-P-1130GC

2

Put wind deflector lamella up with roof switch until lamella roof drive switches off. Press roof switch again until first lamella opens approx. 10 mm to rear.

3

Mark position of lever (3) in relation to lamella roof frame

4

Remove lamella roof drive

Steps 2 and 3 only

AR77.20-P-1810GC

5

Remove guides for lamellas on lamella roof

AR77.20-P-1710GC

6

Push slider (4) toward rear and remove from rail

Installation: When installing the slider (4) insert the catch (6) into the opening (7) on the pull cable (1).

7

Pull pull cable (1) together with connector (5) toward rear out of lamella roof frame.

Installation: Before installing the lamella roof drive check mark for lever (3), move slider (4) if necessary.

8

Reinstall in opposite order

Referenced documents