Removing and installing control cable

AR77.20-P-1400F

Removing and installing control cable

2.11.94

 

Removal, installation

1.1

Remove inside rearview mirror

on model 210

2.1

Remove front dome lamp

on model 210

AR82.20-P-0110F

3

Actuate sliding roof switch in closing direction until siding roof drive switches off

2.2

Remove overhead control panel control module

on models 215, 220

AR82.20-P-1000M

3

Remove sliding/pop-up roof panel

on model 210

AR77.20-P-1000F

on models 220, 215

AR77.20-P-1000M

5

Remove water drain trough (7)

6

Unscrew screws (1)

 Torx bit set

*000589011000



*BA77.20-P-1002-01A

7

Loosen screw (2), disengage sliding roof drive from sliding/pop-up roof frame



 Until drive gear (14) is no longer engaged with pull cable (11)

*BA77.20-P-1003-01A

8

Unscrew screws (3)

9

Unscrew screws (4)

10

Remove covers (5) in direction of arrow

11

Slide tilting bracket approx. 10 cm toward rear

Model 210

12

Push pull cable (11) forward

13

Pull out pull cable (11)

14

Install in opposite order

 Installation:
Before fastening the sliding/pop-up roof drive, check position of tip (15) in relation to edge of lever (16). The tip in the opening at the tilting bracket must coincide with the edge of the lever in front. If necessary correct tilting bracket.

Number

Designation

Model 220

Model 215

BA77.20-P-1002-01A

Screw on sliding roof drive

Torx

Nm

4

4

Allen

Nm

4

4

BA77.20-P-1003-01A

Screw on sliding/pop-up roof frame

Nm

8

8