Adjust seal on tilting/sliding roof cover

AR77.20-P-1360GH

Adjust seal on tilting/sliding roof cover

10.3.99

Adjust

1

Adjust tilting/sliding roof cover

AR77.20-P-1100GH

2

Check seat of seal (1, B) on tilting/sliding roof cover

 The distance between the seal and the tilting/sliding roof cover should be
approx. 0.75 mm

To check pull feeler gauge or credit card between seal and tilting/sliding roof opening

The feeler gauge or credit card should make tight contact in the front area, however, should not pinch. In the rear area and the rear corners less resistance should be felt.

 Feeler gauge

*129589032100

3

Move tilting/sliding roof cover to lift position

4

Adjust seal (1, B) with long wedge (C) or roller (2)

 Do not use sharp objects for adjustment. Seal can be damaged.

If the seal is positioned too tightly on the tilting/sliding roof opening, the tilting/sliding roof operation can be obstructed.

 Increase gap between seal and tilting/sliding roof opening:

Move roller (2) along seal (1,B) with slight pressure

 Increase gap between seal and tilting/sliding roof opening:

Press seal (1,B) with long wedge (C) between clamping channel (A) and tilting/sliding roof cover toward outside uniformly from top to bottom along joint with pressure. Thereby move long wedge (C) at an angle to the joint.

 Reduce gap in radius range: Use appropriate rounded off plastic wedge.

 Long wedge

*115589035900

 Roller

*168589056300