AR77.20-L-1100VA | Adjust tilting/sliding roof panel | 18.12.06 |
MODEL 414 with CODE (DS9) Power glass tilting/sliding roof with sun screen
L77.20-0005-06
1 Trim
2 Tilting/sliding roof panel
3 Bolt
Adjust | |||
Danger! | Risk of injury caused by fingers being pinched or crushed when removing, installing or aligning hoods, doors, trunk lids, tailgates or sliding roof. | Keep body parts and limbs well clear of moving parts. | |
1 | Loosen screws (3) | Torx bit set | |
2 | Adjust tilting/sliding roof panel (2) in relation to exterior roof surface | Determine measuring position (x) by gap dimension (A). | |
Gap dimensions | |||
Height setting | |||
3 | Tighten screws (3) | | |
Torx bit set | |||
4 | Normalize tilting/sliding roof paneling (2) | Hold down switch in tilt position for one second. | |
Checking | |||
5 | Check tilting/sliding roof for proper function and fit |
Electric sliding roof
Number | Designation | Model | ||
BA77.20-P-1002-01A | Bolt to sliding roof drive | Torx | Nm | 4 |
Hexagon socket | Nm | - | ||
Test and adjustment values for tilting/sliding roof
Number | Designation | Model | ||
BE77.20-P-1001-01A | Gap dimensions | Tilting/sliding roof cover, front | mm | 3.08 |
Tilting/sliding roof cover, on side and rear | mm | 3.26 | ||
BE77.20-P-1002-01A | Height setting | Measuring position "A" (x) | mm | - |
Front: deeper than outer skin of roof | mm | 0 to 1 | ||
Rear: higher than outer skin of roof | mm | 0 to 1 | ||
Torx bit set
000 589 01 10 00
Referenced documents
- as0000z001101a Risk of injury caused by fingers being jammed or pinched when removing, installing or aligning hoods, doors, trunk lid/rear-end door or sliding roof.