P72.29-2938-09
Shown on model 177.0 |
1 | Cover | S21/3 | Left rear power window switch | |
3 | Catch hook | S21/4 | Right rear power window switch | |
4 | Catch hook |
Shown on model 247.0 |
1 | Cover |
3 | Catch hook |
4 | Catch hook |
S21/3 | Left rear power window switch |
S21/4 | Right rear power window switch |
P72.29-A003-05
Warning | Risk of injury caused by fingers being jammed or pinched when removing, installing or aligning hoods, doors, trunk lid/rear-end door or sliding roof. | No parts of the body or limbs should be within the operating area when the components are moving. | |
Topical note | Information on preventing damage to electronic components due to electrostatic discharge | ||
| Remove/install | ||
1 | Switch off ignition and store transmitter key outside of transmitter range (min. 2 m). | ||
2 | Unclip the cover (1) from the catch hooks (3) and pull it out carefully until the electrical connector is accessible. | Long wedge | |
3 | Release and disconnect electrical connector. | ||
4 | Unclip left rear power window assembly switch (S21/3) and right rear power window assembly switch (S21/4) from the catch hooks (4) and remove from the cover (1). | ||
5 | Install in the reverse order. |
115 589 03 59 00
Long wedge
Referenced documents
- ah5400p000101a Information on preventing damage to electronic components due to electrostatic discharge
- as0000z001101a Risk of injury caused by fingers being jammed or pinched when removing, installing or aligning hoods, doors, trunk lid/rear-end door or sliding roof.