ar7220s4012e

Remove/install bearing bracket of rear-end door

Type ar · topic 72.20 · version 0100 · 2017-05-13

Applies to: Model 447.6/7 with code W50 (Rear-end door, double-wing, 180 degrees without window) Model 447.6/7 with code W54 (2-wing rear-end door, 270 degrees)

Where it sits

Function group 3 Body › 72 Doors › 72.20 Tailgate, rear door — Series 447 (models 6**, 7**)

EinPAS 29 Drive authorization/security system › 29.16 Locking/unlocking › 29.16.32 Lock/actuation — Series 447 (models 6**, 7**)

AR72.20-S-4012E

Remove/install bearing bracket of rear-end door

28.04.2017

Model

447.6/7

with code W50 (Rear-end door, double-wing, 180 degrees without window)

Model

447.6/7

with code W54 (2-wing rear-end door, 270 degrees)

Remove/install bearing bracket of rear-end door

S72.20-4700-09

1

Rear-end door bearing bracket

5

Bolts

2

Door foil

6

Cable

3

Rear-end door lock

7

Door handle seal

4

Plug

8

Screw

Warning

Risk of injury caused by fingers being jammed or pinched when removing, installing or aligning hoods, doors, trunk lid/rear-end door or sliding roof.

No parts of the body or limbs should be within the operating area when the components are moving.

AS00.00-Z-0011-01A

Topical note

Notes on carrying out repair work in the vehicle interior

AH68.00-N-0001-01S

Remove/install

1

Detach door foil (2) of rear-end door in upper area until door lock of rear-end door (3) can be accessed

AR72.20-S-4100E

Installation: Replace damaged door foil (2).

2

Remove outside door handle from rear-end door

AR72.20-S-2420E

3

Remove stop plug (4)

4

Remove bolts (5)

5

Remove cable (6) from rear-end door bearing bracket (1)

6

Remove door handle seal (7) from rear-end door

7

Unscrew bolt (8)

8

Push door lock of rear-end door (3) to one side and remove rear-end door bearing bracket (1) downward out of rear-end door

9

Install in the reverse order

Check

10

Perform function check of door lock of rear-end door (3) and outside door handle

Referenced documents