D72.20-1240-09
Shown on model 909.6 |
1 | Rear-end door (left) | 4 | Screw | 7 | Paint protective sheet | ||
2 | Rear-end door (right) | 5 | Strap (right) | 8 | Door stop | ||
3 | Screw | 6 | Strap (left) |
| Remove/install | ||
Danger ! | Risk of injury caused by fingers being jammed or pinched when removing, installing or aligning hoods, doors, trunk lid/rear-end door or sliding roof. | No parts of the body or limbs should be within the operating area when the components are moving. | |
1 | Check door check (8) on both hinges, replace if necessary | ||
2 | Unhook strap (5 or 6) | ||
3 | Check paint protective foil (7) for damage, replace if necessary | ||
4 | Unscrew bolts (3, 4) | MODEL 909.6 | |
5 | Lift out rear-end door (1 or 2) | Helper required. | |
When replacing rear-end doors (1, 2), seal felt seams all the way around before painting. | |||
Installation: Clean contact surfaces on hinges before installing rear-end door (1, 2) and apply primer. | |||
6 | Install in the reverse order | ||
7 | Check adjustment of rear-end doors (1, 2), adjust if necessary |
Referenced documents
- ar7220d1032f Adjust rear-end door
- as0000z001101a Risk of injury caused by fingers being jammed or pinched when removing, installing or aligning hoods, doors, trunk lid/rear-end door or sliding roof.