ar7216s4012e

Remove/install door handle bearing bracket of sliding door

Type ar · topic 72.16 · version 0100 · 2017-05-13

Applies to: Model 447, 448

Where it sits

Function group 3 Body › 72 Doors › 72.16 Sliding doors — Series 447 · Series 448

EinPAS 29 Drive authorization/security system › 29.16 Locking/unlocking › 29.16.32 Lock/actuation — Series 447 · Series 448

AR72.16-S-4012E

Remove/install door handle bearing bracket of sliding door

28.04.2017

Model

447, 448

Remove/install door handle bearing bracket of sliding door

S72.16-4660-09

1

Bearing bracket

4

Cable

2

Sliding door

5

Door handle seal

3

Door foil

6

Screw

Warning

Risk of injury caused by fingers being jammed or pinched when removing, installing or aligning hoods, doors, trunk lid/rear-end door or sliding roof.

No parts of the body or limbs should be within the operating area when the components are moving.

AS00.00-Z-0011-01A

Topical note

Notes on carrying out repair work in the vehicle interior

AH68.00-N-0001-01S

Remove/install

1

Remove door trim from sliding door (2)

AR72.16-S-6610E

2

Detach door foil (3) from sliding door (2) until bearing bracket (1) can be accessed

Installation: Replace damaged door foil (3).

3

Remove outside door handle from sliding door (2)

AR72.16-S-2220E

4

Remove door handle seal (5) from sliding door (2)

5

Remove cable (4) from bearing bracket (1)

6

Remove bolt (6)

7

Remove bearing bracket (1) from sliding door (2)

8

Install in the reverse order

Check

9

Perform function check of sliding door lock and outside door handle

Referenced documents