7 | Bottom carriage |
8 | Cap |
9 | Bottom guide rail |
10 | Cap |
11 | Screw |
D72.16-1362-06
Danger ! | Risk of injury caused by fingers being jammed or pinched when removing, installing or aligning hoods, doors, trunk lid/rear-end door or sliding roof. | No parts of the body or limbs should be within the operating area when the components are moving. | |
| Notes on carrying out repair work in the vehicle interior | ||
| Remove/install | ||
1 | Pry out caps (8, 10) with screwdriver | Installation: Replace caps (8, 10). | |
When reusing caps (8, 10), do not damage lower guide rail (9). | |||
| |||
Punch caps (8, 10) with screwdriver in center and pry out. | |||
2 | Remove screws/bolts (11) | ||
3 | Remove lower guide rail (9) from entry | Installation: Position lower sliding rail (7) in lower guide rail (9). | |
4 | Install in the reverse order | ||
| Check | ||
5 | Check adjustment of lower sliding carriage (7) | If necessary: | |
| |||
Adjust flatness and installation depth in relation to B-pillar. | |||
Adjustment screw for lower/upper carriage | |||
Screw/bolt, lower carriage to sliding door |
Referenced documents
- ah6800n000101s Notes on carrying out repair work in the vehicle interior
- ar7216d102302f Adjust evenness, installation depth and stop of sliding door
- as0000z001101a Risk of injury caused by fingers being jammed or pinched when removing, installing or aligning hoods, doors, trunk lid/rear-end door or sliding roof.