Remove/install door handle bearing bracket of sliding door

AR72.16-D-4012TS

Remove/install door handle bearing bracket of sliding door

06.09.2018

Model

907.6/7, 910.6

Shown on model 910.6 with code T16 (Sliding door, right)

1

Bearing bracket

2

Screw

3

Sliding door

4

Seal

5

Cable

6

Cable

 Caution

Risk of injury caused by scraping or cutting body parts on sharp vehicle parts

Always wear protective gloves when working on or near sharp and non-deburred vehicle parts.
Deburr repair panels.

AS00.00-Z-0017-01A

 Warning

Risk of injury caused by fingers being jammed or pinched when removing, installing or aligning hoods, doors, trunk lid/rear-end door or sliding roof.

No parts of the body or limbs should be within the operating area when the components are moving.

AS00.00-Z-0011-01A

Topical note

Notes on carrying out repair work in the vehicle interior

AH68.00-N-0001-01S

 

Remove/install

1

Remove outside door handle on sliding door.

AR72.16-D-2220TS

2

Remove sliding door trim.

Model 907.6/7
with code V4A (Fully lined right load compartment sliding door)

AR72.16-D-6612TSB

Model 907.6/7
except code V4A (Fully lined right load compartment sliding door)
Model 910.6

AR72.16-D-6612TS

3

Release door foil from sliding door (3) until bearing bracket (1) can be accessed.

 Installation: Replace damaged door foil.

4

Unclip cable (5) from bracket (arrow A) and remove from bearing bracket (1).

5

Remove cable (6) from bearing bracket (1).

Model 907.6/7
except code T55 (Electric operation of sliding door on right)
except code T56 (Electric operation of sliding door on left)
Model 910.6

6

Remove seal (4).

7

Loosen screw (2).

 Bolt, bearing bracket to sliding door

*BA72.16-N-1003-01TS

8

Remove bearing bracket (1) from sliding door (3).

9

Install in the reverse order.



Check

10

Check opening, closing and locking function of sliding door (3).

 Sliding door

Number

Designation

Model 907.6/7, 910.6

BA72.16-N-1003-01TS

Bolt, bearing bracket to sliding door

Nm

3