Model | 900.6 |
with code T16 (Sliding door right) | |
with code T55 (Electric operation of sliding door on right) | |
Model | 906.6/7 |
with code T16 (Sliding door right) | |
with code T55 (Electric operation of sliding door on right) | |
except code T19 (Sliding door left) | |
Model | 906.6/7 |
with code T19 (Sliding door left) | |
with code T56 (Electric operation of sliding door on left) | |
except code T16 (Sliding door right) |
D72.16-1278-09
Shown on vehicle with code T16 (Right sliding door) with code T55 (Electrical actuation for right sliding door) |
1 | Tensioner support bushing | 6 | Guide rail | 11 | Carriage | ||
2 | Tensioner | 7 | Bolts | 12 | Release for electrical driver (except CODE PE4 (Mastercode Bus DCAA, Argen) and except CODE PE5 (Mastercode Bus platform seating, Argen) and except CODE T63 (Electrical sliding door release)) | ||
3 | Clamping bolt | 8 | Shaft retainers | M73/1 | Right electric sliding door drive (with CODE T55 (Electrical actuation for right sliding door)) | ||
4 | Drive belt | 9 | Shaft | M73/2 | Left electrical sliding door drive (with code T56 (Electrical actuation for left sliding door)) | ||
5 | Tensioner | 10 | Assembly funnel |
D72.16-1358-08
18 | Emergency release lever (with CODE PE4 (Mastercode Bus DCAA, Argen) or with CODE PE5 (Mastercode Bus platform seating, Argen)) | 20 | Lever (with code T63 (electrical sliding door release)) | |
19 | Outer emergency release (with code T63 (electrical sliding door release)) |
Warning | Risk of injury caused by fingers being jammed or pinched when removing, installing or aligning hoods, doors, trunk lid/rear-end door or sliding roof. | No parts of the body or limbs should be within the operating area when the components are moving. | |
| Remove | ||
1 | Remove bottom door trim |
| |
MODEL 906.633 with CODE ZO1 (James Cook Compact camper) or with CODE ZO2 (James Cook Classic camper) | |||
2.1 | Turn release for electrical drive (12) 180° clockwise to "MAN" position using key | MODEL 900.6 except CODE T63 (Release for electrical sliding door(s)), MODEL 906.6/7 except CODE PE4 (Mastercode Bus DCAA, Argen) and except CODE PE5 (Mastercode Bus platform seating, Argen) | |
Motor coupling of electrical actuating for sliding door is unlocked. | |||
2.2 | Turn emergency release lever (18) outside clockwise | MODEL 906.657 with CODE PE4 (Mastercode Bus DCAA, Argen) or with CODE PE5 (Mastercode Bus platform seating, Argen) | |
Motor coupling of electrical actuating for sliding door is unlocked. | |||
2.3 | Actuate lever (20) of outer emergency release (19) | MODEL 900.6 with CODE T63 (Electrical sliding door release)) | |
Retainer must arrest. | |||
3 | Open sliding door until sliding carriage (11) can be removed | ||
4 | Secure sliding door against falling down | ||
| 000 588 04 80 00 Lifting device | ||
5 | Unscrew clamping bolt (3) | ||
6 | Remove sealant on cap of tensioner support bushing (1) | MODEL 906.657 with CODE PE4 (Mastercode Bus DCAA, Argen) or with CODE PE5 (Mastercode Bus platform seating, Argen) Vehicle with panoramic glazing | |
7 | Remove tensioner support bushing (1) | ||
8 | Remove tensioner (2) with drive belt (4) | ||
9 | Press tensioner (5) in direction of vehicle interior and unhook drive belt (4) from guide rail (6) | ||
10 | Mark installation position of sliding carriage (11) | ||
11 | Remove screw/bolts (7) | ||
12 | Press shaft retainers (8) in direction of arrow and simultaneously remove sliding carriage (11) from right sliding door drive (M73/1) or left sliding door drive (M73/2) | | |
13 | Remove carriage (11) | ||
| Install | ||
14 | Position sliding carriage (11) | ||
15 | Guide shaft (9) over assembly funnel (10) in right electric sliding door drive (M73/1) or left electric sliding door drive (M73/2) and arrest shaft retainers (8) | | |
16 | Fit screw/bolts (7) | Tighten bolts (7) only after adjusting torque. | |
17 | Hook drive belt (4) into guide rail (6) | ||
18 | Insert tensioner (2) with drive belt (4) into guide rail (6) and screw to tensioner support bushing (1) | ||
19 | Pretension drive belt (4) | Only when replacing sliding carriage (11). | |
Initial elongation of electric sliding door drive belt (when renewing) | |||
Spring balance | |||
20 | Adjust tension for drive belt (4) on electric sliding door | ||
Electric sliding door drive belt tension | |||
Spring balance | |||
21 | Remove holding device from sliding door | ||
| 000 588 04 80 00 Lifting device | ||
22 | Adjust sliding door | ||
23 | Install lower door trim |
| |
MODEL 906.633 with CODE ZO1 (James Cook Compact camper) or with CODE ZO2 (James Cook Classic camper) | |||
24.1 | Turn release for electric drive (12) 180° counterclockwise to "AUTO" position using key | MODEL 900.6 except CODE T63 (Release for electrical sliding door(s)), MODEL 906.6/7 except CODE PE4 (Mastercode Bus DCAA, Argen) and except CODE PE5 (Mastercode Bus platform seating, Argen) | |
Motor coupling of electrical actuating for sliding door is locked. | |||
24.2 | Turn emergency release lever (18) counterclockwise to horizontal position | MODEL 906.657 with CODE PE4 (Mastercode Bus DCAA, Argen) or with CODE PE5 (Mastercode Bus platform seating, Argen) | |
Motor coupling of electrical actuating for sliding door is locked. | |||
24.3 | Return lever (20) on outer emergency release (19) to initial position | MODEL 900.6 with CODE T63 (Electrical sliding door release)) | |
Motor coupling of electrical actuating for sliding door is locked. | |||
25 | Install sealant on cap of tensioner support bushing (1) | MODEL 906.657 with CODE PE4 (Mastercode Bus DCAA, Argen) or with CODE PE5 (Mastercode Bus platform seating, Argen) Vehicle with panoramic glazing | |
Sealant 221, 310 ml, DBL 6069.20 | |||
Learn in electric sliding door | |||
26 | Completely open sliding door with switch on center console or door entry and close again | ||
27 | Connect diagnostic system | ||
| |||
28 | Rest cycle number for sliding door | Menu point: Complaints and symptoms. | |
29 | Disconnect diagnostic system | ||
| |||
| Check | ||
30 | Perform function test |
450 589 10 21 00
Spring balance
Referenced documents
- ad0000d200004sd Connect STAR DIAGNOSIS and read out fault memory
- ar7216d1023f Adjust sliding door
- ar7216d230001a Check tension for drive belt of electric sliding door, adjust
- ar7216d230002a Initially elongate drive belt
- ar7216d6610g Remove/install door panel of sliding door
- ar7216s6610jc Remove/install door trim of sliding door
- as0000z001101a Risk of injury caused by fingers being jammed or pinched when removing, installing or aligning hoods, doors, trunk lid/rear-end door or sliding roof.
- ws7200p0018b 000 588 04 80 00 Lifting device