D72.16-1210-09
1 | Sliding door | 7 | Bolts | 13 | Cap | ||
2 | Sliding door stop | 10 | Cap | 14 | Screw | ||
3 | Bolts | 11 | Entrance paneling | 15 | End piece | ||
6 | Sliding base bottom | 12 | Screw |
Danger ! | Risk of injury caused by fingers being jammed or pinched when removing, installing or aligning hoods, doors, trunk lid/rear-end door or sliding roof. | No parts of the body or limbs should be within the operating area when the components are moving. | |
| Remove/install | ||
1 | Unscrew bolt (14) and remove end piece (15) | Bolt, end piece to guide rail | |
2 | Unscrew bolts (3) and remove sliding door stop (2) | Installation: Replace screw/bolts (3). | |
Bolt, sliding door stop on sliding door | |||
3 | Remove sliding door (1) with multi functional lifting/holding device | ||
| 000 588 04 80 00 Lifting device | ||
4 | Unscrew bolts (7) and detach lower carriage (6) from sliding door (1) | Bolt, lower carriage to sliding door | |
5 | Push sliding door (1) toward rear out of guide rails (arrows) and remove | When replacing the sliding door (1), the felt seams must be sealed all the way around before painting. | |
6 | Unclip caps (10, 13) from door sill trim (11) | ||
7 | Unscrew bolts (12) and remove door sill trim (11) | ||
8 | Remove lower sliding carriage (6) | ||
9 | Check bottom sliding carriage (6) for wear and damage, replace if necessary. | ||
10 | Install in the reverse order | ||
11 | Check adjustment of sliding door (1), correct adjustment if necessary |
Referenced documents
- ar7216d1023fa Adjust sliding door
- as0000z001101a Risk of injury caused by fingers being jammed or pinched when removing, installing or aligning hoods, doors, trunk lid/rear-end door or sliding roof.
- ws7200p0018b 000 588 04 80 00 Lifting device