P72.12-2668-09
Illustrated on model 251.1
1 Crank window seal
2 Trim strip
2a Front rubber seal
2b Rear rubber seal
3 Metal clips
| Removing | ||
Danger! | Risk of injury caused by fingers being pinched or crushed when removing, installing or aligning hoods, doors, trunk lids, liftgates or sliding roof | Keep body parts and limbs well clear of moving parts. | |
1 | Open front door, completely move crank window downward | ||
2 | Switch off ignition and remove the transmitter key from the EIS [EZS] control unit | On vehicles with Keyless Go, code 889: Press Keyless Go start/stop button repeatedly until ignition is switched off. Remove transmitter key from vehicle and store it in a location beyond its transmission range (at least 2 m). | |
3 | Pull crank window seal (1) out of upper window frame | For later check of seat for metal clips (3). | |
4 | Remove front rubber seal (2a) and rear rubber seal (2b) | ||
5 | Carefully unclip trim strip (2) in direction of outer door side | The metal clips (3) have a high removal resistance. | |
| Clean | ||
6 | Remove sealant and glue residues from rear door with eraser disc. | Dia. 100 mm removal disk with mounting shaft | |
Drill | |||
7 | Remove sealant and glue residues with scraper | At points on rear door not accessible with eraser disc | |
8 | Clean bonding surfaces on rear door | Bonding surface should be free of grease and dust. | |
Cleaner | |||
| Install | ||
9 | Carefully clip trim strip (2) in direction of inner door side | The metal clips (3) have a high removal resistance. | |
Check whether metal clips (3) are seated correctly, replace damaged metal clips (3). | |||
| Checking | ||
10 | Check ends of trim strip (2) at front (arrows A) and rear (arrows B) | If necessary, correct seat of trim strip (2) | |
| Install | ||
11 | Glue front rubber seal (2a) and rear rubber seal (2b) to window frame from top to bottom, press on with roller | Roller | |
12 | Install crank window sealing (1) and align | Use lubricant | |
Long wedge | |||
Antifriction agent | |||
13 | Switch on ignition, completely move crank window upward |
168 589 05 63 00
Roller
Long wedge
115 589 03 59 00
Repair materials
Number | Designation | Order number |
BR00.45-Z-1025-04A | Cleaner | A 005 989 19 71 |
BR00.45-Z-1010-06A | Lubricant, rubber assembly 1 l | A 000 989 03 67 |
Referenced documents
- as0000z001101a Risk of injury caused by fingers being jammed or pinched when removing, installing or aligning hoods, doors, trunk lid/rear-end door or sliding roof.