Remove/install front door · ar7210w0500a · Mercedes-Benz WIS

AR72.10-W-0500A

Remove/install front door

15.1.08

MODEL 950.0 /1 /2 /3, 952.0 /1 /2 /3, 953.1 /3, 954.0 /1 /2 with BODY 942.899
Front door with door holder

W72.10-0001-06

1 Footwell trim

2 Cable protection conduit

3 Door holder

4 Nut

5 Liftgate hinge

6 Front door

Modification notes

5.12.07

Remove footwell cover (1), added.

Step 2

 	Remove/install
 Danger!	Risk of injury caused by fingers being pinched or crushed when removing, installing or aligning hoods, doors, trunk lids, liftgates or sliding roof	Keep body parts and limbs well clear of moving parts.	AS00.00-Z-0011-01A
1	open front door (6)
2	Remove footwell cover (1)	Driver side	AR68.30-W-1310A
		Passenger side	AR68.30-W-1300A
3	Disconnect electrical connector from door electrical system
4	Disconnect GPS antenna connector	 If present.
5	Detach cable protection conduit (2) from A-pillar cutout and pull wiring harness (6) through
6	Support front door (6) with multifunctional lifting/holding device
7	Remove door holder (3) on A-pillar
8	Unscrew nut (4) at upper and lower door hinge (5)		*BA72.10-N-1006-01B
9	Lift out front door (6) with multifunctional lifting/holding device
10	Install in the reverse order
11	Check gaps and installation depth of door		AR72.10-W-1089A

 Front door

ar6830w1300a Remove/install footwell cover on passenger side
ar6830w1310a Remove/install footwell cover on driver's side
ar7210w1089a Check gaps and installation depth of door
as0000z001101a Risk of injury caused by fingers being jammed or pinched when removing, installing or aligning hoods, doors, trunk lid/rear-end door or sliding roof.