Remove/install crank window in front door

AR72.10-P-1900RT

Remove/install crank window in front door

16.3.10



Remove

1

Remove outer sealing rail

AR72.10-P-1700RT

2

Remove cover in door lining mirror triangle (1) and inner sealing rail (2) from left and right front door

 Treat ribbon cable carefully to prevent damage

AR72.10-P-1600RT

 Do not yet remove power window motor connector from door control unit.

3

Move crank window (7) upward to 105 mm (a) from upper door edge

4

Disconnect connector from door control unit and lay door lining (1) down to side.

 Treat ribbon cable carefully to prevent damage

5

Switch off ignition and remove transmitter key from the EIS [EZS] control unit

 On vehicles with Keyless Go, code 889: Press Keyless Go start/stop button repeatedly until ignition is switched off Remove transmitter key from vehicle and store it in a location beyond its transmission range (at least 2 m).

6

Remove rubber plugs (3) and unscrew
bolts (4)

7

Tilt crank window (7) toward front until rear bottom corner is free, then lift crank window (7) upward and outward out of left and right front door.

 Lift out carefully to prevent damaging paint or crank window (7).



Install

8

Insert crank window (7) first with front bottom corner, then with rear bottom corner into window guide seal.

 Spray lubricant to bottom ends of window guide seal

Antifriction agent

*BR00.45-Z-1010-06A

9

Press crank window (7) into window mounts (5) downward with mounting plates (6).

10

Screw in bolts (4)

 Do not yet tighten bolts (4).

11

Switch on ignition

12

Insert power window motor into door control unit

 Treat ribbon cable carefully to prevent damage

13

Completely roll down crank window (7), then completely roll upward.

 The crank window (1) is aligned by moving up and down

14

Move crank window (7) downward to 105 mm (a) from upper door edge

15

Disconnect connector from power window motor and lay door lining (1) down to side

 Treat ribbon cable carefully to prevent damage

16

Tighten bolts (4) and install rubber
plugs (3)



*BA72.10-P-1002-01P

17

Install inner sealing rail (2), door lining (1) and cover on mirror triangle on left and right front door

AR72.10-P-1600RT

18

Install outer sealing rail

AR72.10-P-1700RT

19

Completely move left front or right front crank window up and down, hold switch in corresponding end position for at least one second.

 The power window motor is synchronized by holding the power window in the corresponding end position for at least 1 s.

Number

Designation

Model 251

BA72.10-P-1002-01P

Bolt, crank window to power window

Nm

7

Number

Designation

Order number

BR00.45-Z-1010-06A

Lubricant, rubber assembly 1 l

A 000 989 03 67