P72.10-3255-09
1 Crank window sealing
2 Trim strip
3 Metal clips
| Remove | ||
Danger! | Risk of injury caused by fingers being jammed or pinched when removing, installing or aligning hoods, doors, trunk lid/rear-end door or sliding roof. | When moving components, ensure that no body parts or limbs are within the operating range of moving parts. | |
1 | Open front door, completely move crank window downward | ||
2 | Switch off ignition and remove the transmitter key from the EIS [EZS] control unit | On vehicles with Keyless Go, code 889: Press Keyless Go start/stop button repeatedly until ignition is switched off. Remove transmitter key from vehicle and store it in a location beyond its transmission range (at least 2 m). | |
3 | Pull crank window seal (1) out of upper window frame | For later check of seat for metal clips (3). | |
4 | Carefully unclip trim strip (2) in direction of outer door side | The metal clips (3) have a high removal resistance. | |
Start at rear on front door | |||
| Install | ||
5 | Carefully clip trim strip (2) in direction of inner door side | The metal clips (3) have a high removal resistance. | |
Start at front of front door | |||
Check whether metal clips (3) are seated correctly, replace damaged metal clips (3). | |||
| Check | ||
6 | Check ends of trim strip (2) at front (arrows A) and rear (arrow B) | If necessary, correct seat of trim strip (2) | |
| Install | ||
7 | Install crank window sealing (1) and align | Use lubricant | |
Long wedge | |||
Antifriction agent | |||
8 | Switch on ignition, completely move crank window upward |
Long wedge
115 589 03 59 00
Repair materials
Number | Designation | Order number |
BR00.45-Z-1010-06A | Lubricant, rubber assembly 1 l | A 000 989 03 67 |
Referenced documents
- as0000z001101a Risk of injury caused by fingers being jammed or pinched when removing, installing or aligning hoods, doors, trunk lid/rear-end door or sliding roof.