ar7210p1400me

Remove/install front door inner actuation

Type ar · topic 72.10 · version 0100 · 2018-10-23

Applies to: Model 167

Where it sits

Function group 3 Body › 72 Doors › 72.10 Front door — Series 167

EinPAS 29 Drive authorization/security system › 29.16 Locking/unlocking › 29.16.32 Lock/actuation — Series 167

AR72.10-P-1400ME

Remove/install front door inner actuation

02.10.2018

Model

167

Remove/install front door inner actuation

P72.10-5040-08

1

Welded spacers

S85/5

Left front central locking system inside door handle switch

2

Inner actuation

S85/6

Right front central locking system inside door handle switch

3

Fiber optic cable

Warning

Risk of injury caused by fingers being jammed or pinched when removing, installing or aligning hoods, doors, trunk lid/rear-end door or sliding roof.

No parts of the body or limbs should be within the operating area when the components are moving.

AS00.00-Z-0011-01A

Caution

Risk of injury caused by scraping or cutting body parts on sharp vehicle parts

Always wear protective gloves when working on or near sharp and non-deburred vehicle parts.
Deburr repair panels.

AS00.00-Z-0017-01A

Remove

1

Remove front door trim.

AR72.10-P-6575ME

2

Remove damping from door trim.

3

Cut off welded spacers (1) with a suitable tool and remove inside door handle (2).

Always install new inside door handle (2).

4

Remove front left central locking system inside door handle switch (S85/5) and front right central locking system inside door handle switch (S85/6).

5

Remove fiber-optic cable (3).

Install

6

Shorten welded spacers (1) of the new actuator (2) by approx. 11 mm.

7

Install fiber-optic cable (3).

8

Install front left central locking system inside door handle switch (S85/5) and front right central locking system inside door handle switch (S85/6) .

9

Fasten new inside door handle (2) with screws and washers on the door trim.

10

Install damping of door trim.

11

Install front door trim.

AR72.10-P-6575ME

Referenced documents