Remove/install front door · ar7210p0500a · Mercedes-Benz WIS

AR72.10-P-0500A

Remove/install front door

22.03.2019

Model	461.217/219/227/229/238/239/249/266/267/321/322/323/326/327/328/329/335/336/337/338/341/365/366/367/368/401/402/403/404/405/450/451/452/454/455/456/458/459
Model	463.200/204/206/207/208/209/220/221/224/225/227/228/230/231/232/233/240/300/304/307/308/320/321/324/325/327/328/330/331
	up to model year 2000
Model	463.241
	up to model year 2019
	except code 979 (Special protection MB Guard)

P72.10-0406-01

P72.10-0389-01

P72.10-2716-01

5	Electrical connector

4	Central locking motor electrical connector

3	Tab
M21/1x1	Left electrically adjustable and heated exterior mirror connector
M21/2x1	Right electrically adjustable and heated exterior mirror connector

6	Bolts for lower hinge on front door
7	Bolts for upper hinge on front door

P72.10-0414-01

P72.10-0413-01

 Warning	Risk of injury caused by fingers being jammed or pinched when removing, installing or aligning hoods, doors, trunk lid/rear-end door or sliding roof.	No parts of the body or limbs should be within the operating area when the components are moving.	AS00.00-Z-0011-01A
Topical note	Information on preventing damage to electronic components due to electrostatic discharge		AH54.00-P-0001-01A
 	Remove/install
1	Disconnect battery ground line	Model 461.217/219/227/229/238/239/249/266/267/321/322/323/326/327/328/329/335/336/337/338/341/365/366/367/368/401/402/403/404/405/450/451/452/454/455/456/458/459 Model 463.204/206/207/208/209/220/221/224/225/227/228/230/231/232/233/240/300/304/307/308/320/321/324/325/327/328/331 up to model year 2000 Model 463.241 up to model year 2008 except code 979 (Special protection MB Guard)	AR54.10-P-0003G
2	Remove front door lining	Model 461.217/219/227/229/238/239/249/266/267/321/322/323/326/327/328/329/335/336/337/338/341/365/366/367/368/401/402/403/404/405/450/451/452/454/455/456/458/459One-piece door lining	AR72.10-P-1000GL
		Model 461.217/219/227/229/238/239/249/266/267/321/322/323/326/327/328/329/335/336/337/338/341/365/366/367/368/401/402/403/404/405/450/451/452/454/455/456/458/459Two-piece door lining	AR72.10-P-1000GV
		Model 463.200/204/206/207/208/209/220/221/224/225/227/228/230/231/232/233/240/300/304/307/308/320/321/324/325/327/328/330/331 up to model year 2000 Model 463.241 up to model year 2013 except code 979 (Special protection MB Guard)	AR72.10-P-1000H
3	Carefully loosen door foil	 Installation: Check door foil for damage, replace if necessary. Otherwise moisture can penetrate into the passenger compartment.
4	Loosen electrical connector (5) of power window motor, unlock and disconnect	If installed.
		 Installation: Ensure that wiring harness is routed and fastened correctly.
5	Loosen electrical connector for central locking motor (4) from front door and disconnect	If installed.
		 Installation: Ensure that wiring harness is routed and fastened correctly.
6	Loosen electrical connector on left heated, adjustable electrical outside mirror (M21/1x1) or right heated, adjustable electrical outside mirror (M21/2x1) on front door, unlock and disconnect	If installed.
		 Installation: Ensure that wiring harness is routed and fastened correctly.
7	Pull out lock (arrow) and bend up shackle (3). Remove electrical plug contacts on body side from connector housing of left heated, adjustable electrical outside mirror (M21/1x1) or right heated, adjustable electrical outside mirror (M21/2x1)	If installed.
		 Removal: Mark plug contacts. To ensure correct installation.
8	Pull grommets out of door frame and front door	 Installation: Ensure that rubber grommet is seated correctly.
9	Pull electric leads out of front door	 Installation: Route electrical lines along original fastening points, do not kink and tension. To prevent damage.
		 Installation: Always replacing mounting material.
10	Unscrew bolts from lower hinge on front door (6)	 Support front door. Otherwise damage or injury can occur.
11	Unscrew bolts from upper hinge on front door (7)	 Support front door. Otherwise damage or injury can occur.
12	Remove front door	 Removal: Mark adjustment panels below hinges on front door. To facilitate positioning during installation.
13	Install in the reverse order
	Measure
14	Adjust front door	Model 461.217/219/227/229/238/239/249/266/267/321/322/323/326/327/328/329/335/336/337/338/341/365/366/367/368/401/402/403/404/405/450/451/452/454/455/456/458/459 Model 463.200/204/206/207/208/209/220/221/224/225/227/228/230/231/232/233/240/300/304/307/308/320/321/324/325/327/328/330/331 up to model year 2000 except code 979 (Special protection MB Guard)	AR72.10-P-0550A
		Model 461.217/219/227/229/238/239/249/266/267/321/322/323/326/327/328/329/335/336/337/338/341/365/366/367/368/401/402/403/404/405/450/451/452/454/455/456/458/459 up to model year 2019 Model 463.200/204/206/207/208/209/220/221/224/225/227/228/230/231/232/233/240/241/300/304/307/308/320/321/324/325/327/328/330/331 up to model year 2000 except code 979 (Special protection MB Guard)	AR72.10-P-0550A

Referenced documents

ah5400p000101a Information on preventing damage to electronic components due to electrostatic discharge
ar5410p0003g Disconnect/connect battery ground line
ar7210p0550a Adjust front door
ar7210p1000gl Remove/install door lining on front door
ar7210p1000glc Remove/install door lining on front door
ar7210p1000gls Remove/install front door lining
ar7210p1000gv Remove/install front door lining
ar7210p1000h Remove/install front door lining
as0000z001101a Risk of injury caused by fingers being jammed or pinched when removing, installing or aligning hoods, doors, trunk lid/rear-end door or sliding roof.