ar7210d2400fa

Remove/install outside door handle on front door

Type ar · topic 72.10 · version 0100 · 2016-07-25

Applies to: Model 909

Where it sits

Function group 3 Body › 72 Doors › 72.10 Front door — Series 909

EinPAS 29 Drive authorization/security system › 29.16 Locking/unlocking › 29.16.32 Lock/actuation — Series 909

AR72.10-D-2400FA

Remove/install outside door handle on front door

15.07.2016

Model

909

Remove/install outside door handle on front door

D72.10-1127-07

Shown on right front door

1	Screw		3	Washer
2	Door handle		4	Washer

 Danger !	Risk of injury caused by fingers being jammed or pinched when removing, installing or aligning hoods, doors, trunk lid/rear-end door or sliding roof.	No parts of the body or limbs should be within the operating area when the components are moving.	AS00.00-Z-0011-01A
 	Remove/install
1	Open front door
2	Remove screw/bolt (1)	 Bolt, outer door handle to hinged door	*BA72.15-N-1010-01A
3	Push door handle (2) (arrow A), pivot out (arrow B) and pull out door handle (2) (arrow C)
4	Check washers (3, 4) for damage and replace if required
5	Transfer lock cylinder	When replacing door handle (2).
			AR72.00-D-4691F
6	Install in the reverse order
	Check
7	Check door handle (2) for proper function

 Hinged doors

Number	Designation		Model 909
BA72.15-N-1010-01A	Bolt, outer door handle to hinged door	Nm	10

Referenced documents

ar7200d4691f Remove/install lock cylinder
as0000z001101a Risk of injury caused by fingers being jammed or pinched when removing, installing or aligning hoods, doors, trunk lid/rear-end door or sliding roof.